IDES Prospector Already have an account? Login Here

IDES

Daelim Po1y® LH-58120UV

High Density Polyethylene

Supplied by DAELIM INDUSTRIAL CO., LTD.

The technical datasheet with complete property values for Daelim Po1y® LH-58120UV is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
General  
Material Status 
  • Commercial: Active
Availability 
  • Asia Pacific
Features 
  • Good Flow
  • Good Stiffness
  • Good Weather Resistance
  • High Gloss
  
Agency Ratings 
 
Forms 
  • Pellets
Processing Method 
  • Injection Molding
Physical
Nominal Value
Unit
Test Method
Density
g/cm³
 ASTM D1505
Melt Mass-Flow Rate (MFR) (190°C/2.16 kg)
g/10 min
 ASTM D1238
Mechanical
Nominal Value
Unit
Test Method
Tensile Strength 2 (Yield)
psi
 ASTM D638
Tensile Elongation 2 (Break)
%
 ASTM D638
Flexural Modulus
psi
 ASTM D790
Impact
Nominal Value
Unit
Test Method
Notched Izod Impact
ft·lb/in
 ASTM D256
Thermal
Nominal Value
Unit
Test Method
Brittleness Temperature
°F
 ASTM D746
Additional Information
Ultimate Elongation, ASTM D-638, Type VI Spec, 50 mm/min: >900%
Brittle Temperature, ASTM D-746: <-118°C
Related Terminology
This supplier and product may also be known by these terms: Daelim Poly, Daelim Po1y

Product names can be difficult to match. You may have searched any one of these terms to find this product: Daelim Po1y® LH-58120UV, Daelim Po1y LH58120UV, Daelim Po1y® , Daelim Po1y, DaelimPo1yLH58120UV, DaelimPo1y, LH, LH 58120 UV, LH-58120UV, LH58120UV, LH:58120UV, LH/58120UV, LH+58120UV, LH_58120UV, LH 58120UV, LH58120, 58120UV, Polyethylene, High Density, Polyethylene High Density, HDPE, Polyethylene, PE, Daelim, PolyethyleneHighDensity, 58120LH
Features
Features may also be described by the following terms: High Gloss, Good Stiffness, Good Flow, Good Weather Resistance, Weather Resistant.
Agency Ratings
This plastic material has 2 certifications from the following agencies (the number in parentheses shows the number of certifications for that agency): FDA (1), ASTM (1).
Injection
Nominal Value
Unit
 
Processing (Melt) Temp
°F
  
Notes
1Typical properties: these are not to be construed as specifications.
22.0 in/min
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.