IDES Prospector Already have an account? Login Here

IDES

Daelim Po1y® LD-08A

Low Density Polyethylene

Supplied by DAELIM INDUSTRIAL CO., LTD.

The technical datasheet with complete property values for Daelim Po1y® LD-08A is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
General  
Material Status 
  • Commercial: Active
Availability 
  • Asia Pacific
Features 
  • Good Heat Seal
  • Good Toughness
  • High Impact Resistance
Uses 
  • Film
Agency Ratings 
 
Forms 
  • Pellets
Physical
Nominal Value
Unit
Test Method
Density
g/cm³
 ASTM D1505
Melt Mass-Flow Rate (MFR) (190°C/2.16 kg)
g/10 min
 ASTM D1238
Films
Nominal Value
Unit
Test Method
Film Thickness - Tested
mil
  
Tensile Strength
     ASTM D882
MD: Break
psi
  
TD: Break
psi
  
Tensile Elongation
     ASTM D882
MD: Break
%
  
TD: Break
%
  
Dart Drop Impact
g
 ASTM D1709
Elmendorf Tear Strength
     ASTM D1922
MD
g
  
TD
g
  
Optical
Nominal Value
Unit
Test Method
Haze
%
 ASTM D1003
Additional Information
Tear Strength, MD, ASTM D-1004: 100kg/cm
Tear Strength, TD, ASTM D-1004: 100kg/cm
Related Terminology
This supplier and product may also be known by these terms: Daelim Poly, Daelim Po1y

Product names can be difficult to match. You may have searched any one of these terms to find this product: Daelim Po1y® LD-08A, Daelim Po1y LD08A, Daelim Po1y® , Daelim Po1y, DaelimPo1yLD08A, DaelimPo1y, LD, LD 08 A, LD-08A, LD08A, LD:08A, LD/08A, LD+08A, LD_08A, LD 08A, LD08, 08A, Polyethylene, Low Density, Polyethylene Low Density, LDPE, Polyethylene, PE, Daelim, PolyethyleneLowDensity, 08LD
Features
Features may also be described by the following terms: High Impact Resistance, Good Toughness, Tough, Good Heat Seal.
Agency Ratings
This plastic material has 2 certifications from the following agencies (the number in parentheses shows the number of certifications for that agency): FDA (1), ASTM (1).
Injection
Nominal Value
Unit
 
Processing (Melt) Temp
°F
  
Notes
1Typical properties: these are not to be construed as specifications.
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.