Daelim Po1y LD-37 Daelim Polyethylene, Low Density

General

Material Status

Availability

Features

Uses

Agency Ratings

Forms

Processing Method

Physical	Nominal Value	Unit	Test Method
Density		g/cm³	ASTM D1505
Melt Mass-Flow Rate (MFR) (190°C/2.16 kg)		g/10 min	ASTM D1238
Mechanical	Nominal Value	Unit	Test Method
Tensile Strength			ASTM D638
Yield		psi
Break		psi
Tensile Elongation (Break)		%	ASTM D638
Flexural Modulus		psi	ASTM D790
Films	Nominal Value	Unit	Test Method
Film Thickness - Tested		mil
Tensile Strength			ASTM D882
MD: Break		psi
TD: Break		psi
Dart Drop Impact		g	ASTM D1709
Hardness	Nominal Value	Unit	Test Method
Durometer Hardness (Shore D)			ASTM D2240
Thermal	Nominal Value	Unit	Test Method
Vicat Softening Temperature		°F	ASTM D1525
Related Terminology
This supplier and product may also be known by these terms: Daelim Poly, Daelim Po1y Product names can be difficult to match. You may have searched any one of these terms to find this product: Daelim Po1y® LD-37, Daelim Po1y LD37, Daelim Po1y® , Daelim Po1y, DaelimPo1yLD37, DaelimPo1y, LD, LD-37, LD37, LD:37, LD/37, LD+37, LD_37, LD 37, Polyethylene, Low Density, Polyethylene Low Density, LDPE, Polyethylene, PE, Daelim, PolyethyleneLowDensity, 37LD
Features
Features may also be described by the following terms: Good Processability, Easy Processing, Low Shrinkage, Low Warpage, Low Warp.
Agency Ratings
This plastic material has 2 certifications from the following agencies (the number in parentheses shows the number of certifications for that agency): FDA (1), ASTM (1).

Injection	Nominal Value	Unit
Processing (Melt) Temp		°F

Notes

¹Typical properties: these are not to be construed as specifications.

Daelim Po1y® LD-37