Daelim Po1y LL-24W Daelim Polyethylene, Linear Low Density

General

Material Status

Availability

Features

Uses

Agency Ratings

Forms

Physical	Nominal Value	Unit	Test Method
Density		g/cm³	ASTM D1505
Melt Mass-Flow Rate (MFR) (190°C/2.16 kg)		g/10 min	ASTM D1238
Films	Nominal Value	Unit	Test Method
Film Thickness - Tested		mil
Tensile Strength			ASTM D882
MD: Yield		psi
TD: Yield		psi
MD: Break		psi
TD: Break		psi
Tensile Elongation			ASTM D882
MD: Break		%
TD: Break		%
Dart Drop Impact		g	ASTM D1709
Elmendorf Tear Strength			ASTM D1922
MD		g
TD		g
Optical	Nominal Value	Unit	Test Method
Haze		%	ASTM D1003
Additional Information
Tear Strength, MD, ASTM D-1004: 140kg/cm Tear Strength, TD, ASTM D-1004: 120kg/cm
Related Terminology
This supplier and product may also be known by these terms: Daelim Poly, Daelim Po1y Product names can be difficult to match. You may have searched any one of these terms to find this product: Daelim Po1y® LL-24W, Daelim Po1y LL24W, Daelim Po1y® , Daelim Po1y, DaelimPo1yLL24W, DaelimPo1y, LL, LL 24 W, LL-24W, LL24W, LL:24W, LL/24W, LL+24W, LL_24W, LL 24W, LL24, 24W, Polyethylene, Linear Low Density, Polyethylene Linear Low Density, LLDPE, Polyethylene, PE, Daelim, PolyethyleneLinearLowDensity, 24LL
Features
Features may also be described by the following terms: Good Processability, Easy Processing, High Clarity, High Environmental Stress Cracking Resistance, High ESCR, Stress Cracking Resistant.
Uses
Uses may also be described by the following terms: Piping, Pipe.
Agency Ratings
This plastic material has 2 certifications from the following agencies (the number in parentheses shows the number of certifications for that agency): FDA (1), ASTM (1).

Injection	Nominal Value	Unit
Processing (Melt) Temp		°F

Notes

¹Typical properties: these are not to be construed as specifications.

Daelim Po1y® LL-24W