UBESTA 3024 GC6 UBE Engineering Plastics Polyamide 12 (Glass Fiber Reinforcement, 30%)

Product Description

UBESTA 3024 GC6 is a glass fibre reinforced Polyamide 12 for injection moulding application.

General

Material Status

Availability

Filler / Reinforcement

Additive

Features

Appearance

Forms

Processing Method

Physical	Nominal Value	Unit	Test Method
Density		g/cm³	ISO 1183
Melt Mass-Flow Rate (MFR) (235°C/2.16 kg)		g/10 min	ISO 1133
Molding Shrinkage			ISO 294-4
Across Flow		%
Flow		%
Water Absorption (73°F, 24 hr)		%	ISO 62
Mechanical	Nominal Value	Unit	Test Method
Tensile Stress (Yield)		psi	ISO 527-2
Tensile Strain (Break)		%	ISO 527-2
Flexural Modulus		psi	ISO 178
Flexural Strength		psi	ISO 178
Impact	Nominal Value	Unit	Test Method
Charpy Notched Impact Strength			ISO 179/1eA
-40°F, Complete Break		ft·lb/in²
73°F, Complete Break		ft·lb/in²
Hardness	Nominal Value	Unit	Test Method
Rockwell Hardness (R-Scale)			ISO 2039-2
Thermal	Nominal Value	Unit	Test Method
Heat Deflection Temperature
66 psi, Unannealed		°F	ISO 75-2/B
264 psi, Unannealed		°F	ISO 75-2/A
Melting Temperature (DSC)		°F	ISO 3146
CLTE - Flow		in/in/°F	ISO 11359-2
Electrical	Nominal Value	Unit	Test Method
Volume Resistivity		ohm·cm	IEC 60093
Additional Information
The value listed as Melting Temperature, ISO 3146, was tested in accordance with ISO 11357. Abrasion Loss, ISO 9352, CS-17, 1000 rev.: 12 mg
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: UBESTA 3024 GC6, UBESTA , UBESTA3024GC6, 3024 GC 6, 3024 GC6, 3024GC, GC6, 3024GC6, Polyamide 12, Nylon 12, Polyamide, Nylon, pa12, UBE Engineering Plastics, Polyamide12, Nylon12, GC3024
Generic Name
Generic Name may also be described by the following terms: PA12.
Features
Features may also be described by the following terms: Good Flow, Good Surface Finish, Good Moldability.

Notes

¹Typical properties: these are not to be construed as specifications.

UBESTA 3024 GC6