IDES Prospector Already have an account? Login Here

IDES

Geon™ Vinyl Dry Blend E1354

Rigid Polyvinyl Chloride

Supplied by PolyOne Corporation

The technical datasheet with complete property values for Geon™ Vinyl Dry Blend E1354 is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
General  
Material Status 
  • Commercial: Active
Availability 
  • Africa & Middle East
  • Asia Pacific
  • Europe
  • North America
  • South America
Uses 
  • Piping
Agency Ratings 
 
Forms 
  • Powder
Processing Method 
  • Extrusion
Physical
Nominal Value
Unit
Test Method
Specific Gravity
 
 ASTM D792
PVC Cell Classification
 
 ASTM D1784
Mechanical
Nominal Value
Unit
Test Method
Tensile Modulus 2
psi
 ASTM D638
Tensile Strength 2 (Yield)
psi
 ASTM D638
Flexural Modulus
psi
 ASTM D790
Flexural Strength
psi
 ASTM D790
Impact
Nominal Value
Unit
Test Method
Notched Izod Impact (73°F, 0.125 in, Compression Molded)
ft·lb/in
 ASTM D256A
Drop Impact Resistance
     ASTM D4226
73°F 3
in·lb/mil
  
73°F 4
in·lb/mil
  
Thermal
Nominal Value
Unit
Test Method
Deflection Temperature Under Load (264 psi, Unannealed, 0.125 in)
°F
 ASTM D648
CLTE - Flow
in/in/°F
 ASTM D696
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: Geon™ Vinyl Dry Blend E1354, Geon Vinyl Dry Blend E1354, Geon™ Vinyl Dry Blend , Geon Vinyl Dry Blend, GeonVinylDryBlendE1354, GeonVinylDryBlend, BlendE 1354, BlendE1354, Blend, E 1354, E1354, Polyvinyl Chloride, Rigid, Polyvinyl Chloride Rigid, PVC, Rigid, PVC Rigid, Polyvinyl Chloride, PVC, PolyOne, PolyvinylChlorideRigid, PVCRigid, PolyvinylChloride, 1354E, 1354BlendE
Uses
Uses may also be described by the following terms: Piping, Pipe.
Agency Ratings
This plastic material has 4 certifications from the following agencies (the number in parentheses shows the number of certifications for that agency): CSA (1), NSF (3).
Notes
1Typical properties: these are not to be construed as specifications.
2Type I, 0.20 in/min
3Procedure A, C.125 Dart
4Procedure B, C.125 Dart
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.