IDES Prospector Already have an account? Login Here

IDES

Sebiform C25

Polyamide 6

Supplied by Sebi Innovative Compounds

The technical datasheet with complete property values for Sebiform C25 is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
Product Description
Screw Speed: Moderate.
General  
Material Status 
  • Commercial: Active
Availability 
  • Europe
  • North America
  
Features 
  • Crystalline
  • Good Creep Resistance
  • Good Dimensional Stability
  • Good Wear Resistance
  • High Rigidity
  • Low Friction
  • Self Lubricating
  • Solvent Resistant
Forms 
  • Pellets
Physical
Nominal Value
Unit
Test Method
Density
g/cm³
 ASTM D1505
Melt Mass-Flow Rate (MFR) (190°C/2.16 kg)
g/10 min
 ASTM D1238
Molding Shrinkage - Flow
in/in
 ASTM D955
Water Absorption
     ASTM D570
24 hr
%
  
Saturation
%
  
Mechanical
Nominal Value
Unit
Test Method
Tensile Strength
psi
 ASTM D638
Tensile Elongation (Break)
%
 ASTM D638
Flexural Modulus
psi
 ASTM D790
Flexural Strength
psi
 ASTM D790
Impact
Nominal Value
Unit
Test Method
Notched Izod Impact (0.126 in)
ft·lb/in
 ASTM D256
Thermal
Nominal Value
Unit
Test Method
Deflection Temperature Under Load
     ASTM D648
66 psi, Unannealed
°F
  
264 psi, Unannealed
°F
  
Vicat Softening Temperature
°F
 ASTM D1525 2
Melting Temperature
°F
  
Flammability
Nominal Value
Unit
Test Method
Flame Rating - UL (0.0315 in)
 
 UL 94
UL
Nominal Value
Unit
Test Method
Comparative Tracking Index (CTI)
V
 UL 746
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: Sebiform C25, Sebiform , SebiformC25, C 25, C25, Polyamide 6, Nylon 6, Polyamide, Nylon, pa6, Sebi, Polyamide6, Nylon6, 25C
Generic Name
Generic Name may also be described by the following terms: PA6.
Features
Features may also be described by the following terms: High Rigidity, Good Dimensional Stability, Dimensionally Stable, Self-Lubricating, Self Lubricating, Good Wear Resistance, Wear Resistant, Low Friction, Good Creep Resistance, Creep Resistant.
Injection
Nominal Value
Unit
 
Drying Temperature
°F
  
Drying Time
hr
  
Rear Temperature
°F
  
Middle Temperature
°F
  
Front Temperature
°F
  
Nozzle Temperature
°F
  
Mold Temperature
°F
  
Injection Rate
 
  
Injection Notes
Acetal resins do not normally require any drying process because they are not HYGROSCOPIC.
Notes
1Typical properties: these are not to be construed as specifications.
2Rate B (120°C/h)
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.