IDES Prospector Already have an account? Login Here

IDES

Braskem PP 6D43

Polypropylene Random Copolymer

Supplied by Braskem America Inc.

The technical datasheet with complete property values for Braskem PP 6D43 is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
Product Description
Braskem 6D43 Polypropylene Resin is intended for use in fiber spinning processes.

  • Consistent processability
  • Good spinning characteristics

Complies with:
  • U.S. FDA 21 CFR 177.1520 (c)3.1a
  • European Commission Regulation (EU) No 10/2011
Consult the regulations for complete details.
General  
Material Status 
  • Commercial: Active
Availability 
  • Asia Pacific
  • Latin America
  • North America
Agency Ratings 
 
Forms 
  • Pellets
Processing Method 
  • Fiber (Spinning) Extrusion
Physical
Nominal Value
Unit
Test Method
Specific Gravity
 
ASTM D792
Melt Mass-Flow Rate (MFR) (230°C/2.16 kg)
g/10 min
ASTM D1238
Mechanical
Nominal Value
Unit
Test Method
Tensile Strength 2 (Yield)
psi
ASTM D638
Tensile Elongation 2 (Yield)
%
ASTM D638
Flexural Modulus - 1% Secant 2
psi
ASTM D790A
Impact
Nominal Value
Unit
Test Method
Notched Izod Impact 2 (73°F)
ft·lb/in
ASTM D256A
Hardness
Nominal Value
Unit
Test Method
Rockwell Hardness 2 (R-Scale)
 
ASTM D785
Thermal
Nominal Value
Unit
Test Method
Deflection Temperature Under Load 2 (66 psi, Unannealed)
°F
ASTM D648
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: Braskem PP 6D43, Braskem PP , BraskemPP6D43, BraskemPP, PP 6 D 43, PP6D43, PP6, PP, 6 D 43, 6D43, 6D, D43, Polypropylene Random Copolymer, PP Random Copolymer, Polypropylene, PolypropyleneRandomCopolymer, PPRandomCopolymer, D6, 6PP
Agency Ratings
This plastic material has 2 certifications from the following agencies (the number in parentheses shows the number of certifications for that agency): FDA (1), EU (1).
Notes
1Typical properties: these are not to be construed as specifications.
2Testing performed on ASTM D 638 Type I specimen, molded and tested in accordance with ASTM D 4101. Properties will vary with changes in molding conditions and aging time.
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.