IDES Prospector Already have an account? Login Here

IDES

SCLAIR® 2712

High Density Polyethylene

Supplied by NOVA Chemicals

The technical datasheet with complete property values for SCLAIR® 2712 is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
General  
Material Status 
  • Commercial: Active
Availability 
  • North America
Additive 
  • Antioxidant
Features 
  • Antioxidant
  • Food Contact Acceptable
  • Good Impact Resistance
  • Good Organoleptic Properties
  • Good Stiffness
  • High Gloss
  • Warp Resistant
Uses 
  • Caps
  • Closures
  • Food Containers
  • Household Goods
  
Agency Ratings 
Forms 
  • Pellets
Processing Method 
  • Injection Molding
Physical
Nominal Value
Unit
Test Method
Specific Gravity
 
 ASTM D792
Melt Mass-Flow Rate (MFR) (190°C/2.16 kg)
g/10 min
 ASTM D1238
Mechanical
Nominal Value
Unit
Test Method
Tensile Strength 2 (Yield)
psi
 ASTM D638
Tensile Elongation 2 (Break)
%
 ASTM D638
Flexural Modulus
psi
 ASTM D790
Hardness
Nominal Value
Unit
Test Method
Durometer Hardness (Shore D)
 
 ASTM D2240
Thermal
Nominal Value
Unit
Test Method
Brittleness Temperature
°F
 ASTM D746
Vicat Softening Temperature
°F
 ASTM D1525
Additional Information
Nominal Value
Unit
Test Method
Snake Flow
in
 Internal Method
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: SCLAIR® 2712, SCLAIR 2712, SCLAIR® , SCLAIR, SCLAIR2712, 2712, Polyethylene, High Density, Polyethylene High Density, HDPE, Polyethylene, PE, Nova Chemicals, PolyethyleneHighDensity
Features
Features may also be described by the following terms: Warp Resistant, Warpage Resistant, High Gloss, Good Stiffness, Good Impact Resistance, Good Organoleptic Properties.
Uses
Uses may also be described by the following terms: Food Containers, Food Container, Closure Caps, Caps, Cap, Household Goods, Housewares.
Agency Ratings
This plastic material has 1 certifications from the following agencies (the number in parentheses shows the number of certifications for that agency): FDA (1).
Injection
Nominal Value
Unit
 
Processing (Melt) Temp
°F
  
Notes
1Typical properties: these are not to be construed as specifications.
22.0 in/min
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.