LongLite T375J Dowell Trading Phenolic

General
Material Status	Commercial: Active
Availability	North America
Features	Medium Heat Resistance
Uses	Electrical/Electronic Applications
Appearance	Black
Forms	Pellets
Processing Method	Injection Molding

Physical	Nominal Value	Unit	Test Method
Specific Gravity			ASTM D792
Molding Shrinkage - Flow			ASTM D955
Compression Molded		in/in
Injection Molded		in/in
Transfer Molded		in/in
Water Absorption (Equilibrium)		%	ASTM D570
Mechanical	Nominal Value	Unit	Test Method
Tensile Strength		psi	ASTM D638
Flexural Strength		psi	ASTM D790
Compressive Modulus		psi	ASTM D695
Impact	Nominal Value	Unit	Test Method
Charpy Notched Impact Strength		ft·lb/in	ASTM D256
Notched Izod Impact		ft·lb/in	ASTM D256
Thermal	Nominal Value	Unit	Test Method
Deflection Temperature Under Load (264 psi, Unannealed)		°F	ASTM D648
Electrical	Nominal Value	Unit	Test Method
Surface Resistivity		ohms	ASTM D257
Volume Resistivity		ohm·cm	ASTM D257
Dielectric Strength		V/mil	ASTM D149
Arc Resistance		sec	ASTM D495
Flammability	Nominal Value	Unit	Test Method
Flame Rating - UL (0.0311 in)			UL 94
UL	Nominal Value	Unit	Test Method
Comparative Tracking Index (CTI) (PLC)			UL 746
Additional Information
The value listed for Tensile Strength, ASTM D638, was tested in accordance to ASTM D651 test methods. Heat Resistance, ASTM D648, 2 hours: 200°C Insulation Resistance, ASTM D257, After Boiling: 1x10^9 ASTM Grade, ASTM D700: 13
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: LongLite T375J, LongLite , LongLiteT375J, T 375 J, T375J, T375, 375J, Phenolic, Dowell Trading, 375T
Features
Features may also be described by the following terms: Medium Heat Resistance.
Uses
Uses may also be described by the following terms: Electrical Applications, Electronic Applications, Electrical/Electronic Applications, Electrical Sector.

Injection	Nominal Value	Unit
Rear Temperature		°F
Front Temperature		°F
Mold Temperature		°F
Screw Speed		rpm
Injection Notes
For Stiff to Medium Flow: Weight (g)/shot: under 300; Mold Temperature: 160 to 180°C; Front Temperature: 85 to 95°C; Rear Temperature: 60 to 80°C; Screw Revolution: 40 to 60 rpm; Cure Time: 6 to 10 seconds per 1 mm of mold thickness. For Soft Flow: Weight (g)/shot: above 300; Mold Temperature: 165 to 190°C; Front Temperature: 85 to 95°C; Rear Temperature: 55 to 75°C; Screw Revolution: 40 to 60 rpm; Cure Time: 6 to 10 seconds per 1 mm of mold thickness.

Notes

¹Typical properties: these are not to be construed as specifications.

LongLite T375J

Phenolic

Supplied by Dowell Trading Company Ltd.