IDES Prospector Already have an account? Login Here

IDES

OP - Acetal 20GF

Acetal (POM) Copolymer

Glass Fiber Reinforcement, 20%

Supplied by Oxford Polymers

The technical datasheet with complete property values for OP - Acetal 20GF is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
General  
Material Status 
  • Commercial: Active
Availability 
  • North America
Filler / Reinforcement 
  • Glass Fiber Reinforcement, 20% Filler by Weight
Additive 
  • Heat Stabilizer
  • Lubricant
  • Mold Release
Features 
  • Good Mold Release
  • Heat Stabilized
  • Lubricated
Appearance 
  • Colors Available
Forms 
  • Pellets
Processing Method 
  • Injection Molding
Physical
Nominal Value
Unit
Test Method
Specific Gravity
 
 ASTM D792
Molding Shrinkage - Flow (0.125 in)
in/in
 ASTM D955
Water Absorption (Saturation)
%
 ASTM D570
Mechanical
Nominal Value
Unit
Test Method
Tensile Strength
psi
 ASTM D638
Tensile Elongation (Break)
%
 ASTM D638
Flexural Modulus
psi
 ASTM D790
Flexural Strength
psi
 ASTM D790
Impact
Nominal Value
Unit
Test Method
Notched Izod Impact (73°F, 0.125 in)
ft·lb/in
 ASTM D256
Thermal
Nominal Value
Unit
Test Method
Deflection Temperature Under Load (264 psi, Unannealed)
°F
 ASTM D648
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: OP - Acetal 20GF, OP Acetal 20GF, OP - Acetal , OP Acetal, OP : Acetal, OP / Acetal, OP + Acetal, OP _ Acetal, OP Acetal, OPAcetal20GF, OPAcetal, Acetal 20 GF, OP_Acetal, Acetal20GF, Acetal20, Acetal, 20 GF, 20GF, Acetal Copolymer, Acetal Copolymer, Acetal (POM) Copolymer, Acetal POM Copolymer, pom, Oxford Polymers, AcetalPOMCopolymer, GF20, 20Acetal
Features
Features may also be described by the following terms: Good Mold Release, Easy Release, Good Demolding, Heat Stabilized, Heat-ageing Stabilized, Heat Ageing Stabilized, Heat-aging Stabilized, Heat Aging Stabilized.
Injection
Nominal Value
Unit
 
Drying Temperature
°F
  
Drying Time
hr
  
Rear Temperature
°F
  
Middle Temperature
°F
  
Front Temperature
°F
  
Nozzle Temperature
°F
  
Processing (Melt) Temp
°F
  
Mold Temperature
°F
  
Notes
1Typical properties: these are not to be construed as specifications.
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.