IDES Prospector Already have an account? Login Here

IDES

SEP™ SS Nylon 12

Polyamide 12

Supplied by Foster Corporation

The technical datasheet with complete property values for SEP™ SS Nylon 12 is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
General  
Material Status 
  • Commercial: Active
Availability 
  • North America
Features 
  • Flame Retardant
  • Good Stiffness
  • High Rigidity
Uses 
  • Film
  • Tubing
  
Appearance 
  • Clear/Transparent
Forms 
  • Pellets
Processing Method 
  • Injection Molding
Physical
Nominal Value
Unit
Test Method
Specific Gravity
 
 ASTM D792
Melt Mass-Flow Rate (MFR) (275°C/5.0 kg)
g/10 min
 ASTM D1238
Mechanical
Nominal Value
Unit
Test Method
Tensile Modulus
psi
 ASTM D638
Tensile Strength
     ASTM D638
Yield
psi
  
Break
psi
  
50% Strain
psi
  
Tensile Elongation (Break)
%
 ASTM D638
Flexural Modulus
psi
 ASTM D790
Hardness
Nominal Value
Unit
Test Method
Durometer Hardness (Shore D)
 
 ASTM D2240
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: SEP™ SS Nylon 12, SEP SS Nylon 12, SEP™ , SEP, SEPSSNylon12, SS Nylon 12, SSNylon, Nylon12, SSNylon12, Polyamide 12, Nylon 12, Polyamide, Nylon, pa12, Foster, Polyamide12, NylonSS
Generic Name
Generic Name may also be described by the following terms: PA12.
Features
Features may also be described by the following terms: Good Stiffness, High Rigidity.
Uses
Uses may also be described by the following terms: Tubing, Tube.
Injection
Nominal Value
Unit
 
Processing (Melt) Temp
°F
  
Notes
1Typical properties: these are not to be construed as specifications.
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.