IDES Prospector Already have an account? Login Here

IDES

SANTAC® ST-30

Acrylonitrile Butadiene Styrene

Supplied by Nippon A&L Inc.

The technical datasheet with complete property values for SANTAC® ST-30 is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
General  
Material Status 
  • Commercial: Active
Availability 
  • Asia Pacific
  • North America
  
Features 
  • Low Gloss
Forms 
  • Pellets
Processing Method 
  • Injection Molding
Physical
Nominal Value
Unit
Test Method
Density
g/cm³
 ISO 1183
Melt Volume-Flow Rate (MVR) (220°C/10.0 kg)
in³/10min
 ISO 1133
Mechanical
Nominal Value
Unit
Test Method
Tensile Stress (Yield, 73°F)
psi
 ISO 527-2
Flexural Modulus (73°F)
psi
 ISO 178
Flexural Strength (73°F)
psi
 ISO 178
Impact
Nominal Value
Unit
Test Method
Charpy Notched Impact Strength (73°F)
ft·lb/in²
 ISO 179
Hardness
Nominal Value
Unit
Test Method
Rockwell Hardness (R-Scale, 73°F)
 
 ISO 2039-2
Thermal
Nominal Value
Unit
Test Method
Heat Deflection Temperature (264 psi, Unannealed)
°F
 ISO 75-2/A
Flammability
Nominal Value
Unit
Test Method
Flame Rating - UL
 
 UL 94
Additional Information
Ball Pressure Registration Temperature: 95°C
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: SANTAC® ST-30, SANTAC ST30, SANTAC® , SANTAC, SANTACST30, ST, ST-30, ST30, ST:30, ST/30, ST+30, ST_30, ST 30, Acrylonitrile Butadiene Styrene, ABS, Nippon A&L, AcrylonitrileButadieneStyrene, 30ST
Features
Features may also be described by the following terms: Low Gloss.
Injection
Nominal Value
Unit
 
Drying Temperature
°F
  
Drying Time
hr
  
Rear Temperature
°F
  
Middle Temperature
°F
  
Front Temperature
°F
  
Mold Temperature
°F
  
Notes
1Typical properties: these are not to be construed as specifications.
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.