IDES Prospector Already have an account? Login Here

IDES

Westlake HDPE HM 4030

High Density Polyethylene

Supplied by Westlake Chemical Corporation

The technical datasheet with complete property values for Westlake HDPE HM 4030 is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
General  
Material Status 
  • Commercial: Active
Availability 
  • Africa & Middle East
  • Asia Pacific
  • Europe
  • Latin America
  • North America
  • South America
Features 
  • Medium Flow
Uses 
  • Caps
  • Closures
  • Household Goods
  • Lawn and Garden Equipment
  
Agency Ratings 
Forms 
  • Pellets
Physical
Nominal Value
Unit
Test Method
Density
g/cm³
 ASTM D1505
Melt Mass-Flow Rate (MFR) (190°C/2.16 kg)
g/10 min
 ASTM D1238
Mechanical
Nominal Value
Unit
Test Method
Tensile Strength 2 (Yield)
psi
 ASTM D638
Tensile Elongation 2 (Break)
%
 ASTM D638
Flexural Modulus
psi
 ASTM D790A
Impact
Nominal Value
Unit
Test Method
Notched Izod Impact (73°F)
ft·lb/in
 ASTM D256
Hardness
Nominal Value
Unit
Test Method
Durometer Hardness (Shore D)
 
 ASTM D2240
Thermal
Nominal Value
Unit
Test Method
Vicat Softening Temperature
°F
 ASTM D1525
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: Westlake HDPE HM 4030, Westlake HDPE , WestlakeHDPEHM4030, WestlakeHDPE, HDPEHM 4030, HDPE, HDPEHM4030, HM 4030, HM4030, Polyethylene, High Density, Polyethylene High Density, Polyethylene, PE, Westlake Chem, PolyethyleneHighDensity, 4030HM, 4030HDPEHM
Features
Features may also be described by the following terms: Medium Flow, Medium Melt, Medium MFI.
Uses
Uses may also be described by the following terms: Lawn and Garden Equipment, Lawn Equipment, Garden Equipment, Household Goods, Housewares, Closure Caps, Caps, Cap.
Agency Ratings
This plastic material has 1 certifications from the following agencies (the number in parentheses shows the number of certifications for that agency): FDA (1).
Extrusion Notes
Specific recommendations for the conditions under which the resin should be processed can be made only when the end use application, required properties, and the processing equipment are known. For exact recommendations, please contact your Westlake Polymers technical representative.
Notes
1Typical properties: these are not to be construed as specifications.
22.0 in/min
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.