IDES Prospector Already have an account? Login Here

IDES

Kostrate® EDGE 1155

Thermoplastic

Supplied by Plastic Selection Group, Inc.

The technical datasheet with complete property values for Kostrate® EDGE 1155 is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
Product Description
KOSTRATE EDGE 1155 can be used as an impact modifier at a rate of 1 to 5%. Recommend 2 to 3% LDR as a start.
General  
Material Status 
  • Commercial: Active
Availability 
  • North America
Forms 
  • Pellets
Physical
Nominal Value
Unit
Test Method
Melt Mass-Flow Rate (MFR)
g/10 min
 ISO 1133
Elastomers
Nominal Value
Unit
Test Method
Tensile Stress (300% Strain)
psi
 ISO 37
Hardness
Nominal Value
Unit
Test Method
Shore Hardness (Shore A)
 
 ISO 868
Additional Information
Melt Mass-Flow Rate, ISO 1133, 190°C: 1.8 to 4.2 gm/10 min
Tensile Strength, ISO 37: 28 MPa
Specific Gravity, ISO 2781: .96 mg/m³
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: Kostrate® EDGE 1155, Kostrate EDGE 1155, Kostrate® , Kostrate, KostrateEDGE1155, EDGE 1155, EDGE1155, Thermoplastic, Unspecified, Thermoplastic Unspecified, TP, Unspecified, TP Unspecified, Plastic Sel Grp, ThermoplasticUnspecified, TPUnspecified, 1155EDGE
Notes
1Typical properties: these are not to be construed as specifications.
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.