IDES Prospector Already have an account? Login Here

IDES

HIVAL® 506060

High Density Polyethylene

Supplied by Nexeo Solutions, LLC.

The technical datasheet with complete property values for HIVAL® 506060 is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
General  
Material Status 
  • Commercial: Active
Availability 
  • North America
Features 
  • Food Contact Acceptable
Uses 
  • Pails
Agency Ratings 
RoHS Compliance 
Forms 
  • Pellets
Processing Method 
  • Injection Molding
Physical
Nominal Value
Unit
Test Method
Density
g/cm³
ASTM D1505
Melt Mass-Flow Rate (MFR) (190°C/2.16 kg)
g/10 min
ASTM D1238
Environmental Stress-Cracking Resistance (100% Igepal, F50)
hr
ASTM D1693
Mechanical
Nominal Value
Unit
Test Method
Tensile Strength (Yield)
psi
ASTM D638
Tensile Elongation (Break)
%
ASTM D638
Flexural Modulus - 1% Secant
psi
ASTM D790
Impact
Nominal Value
Unit
Test Method
Notched Izod Impact (-40°F)
ft·lb/in
ASTM D256
Tensile Impact Strength (-40°F)
ft·lb/in²
ASTM D1822
Thermal
Nominal Value
Unit
Test Method
Deflection Temperature Under Load
    ASTM D648
66 psi, Unannealed
°F
 
264 psi, Unannealed
°F
 
Melting Temperature
°F
 
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: HIVAL® 506060, HIVAL 506060, HIVAL® , HIVAL, HIVAL506060, 506060, Polyethylene, High Density, Polyethylene High Density, HDPE, Polyethylene, PE, Nexeo, PolyethyleneHighDensity
Agency Ratings
This plastic material has 1 certifications from the following agencies (the number in parentheses shows the number of certifications for that agency): FDA (1).
Injection
Nominal Value
Unit
 
Rear Temperature
°F
 
Middle Temperature
°F
 
Front Temperature
°F
 
Nozzle Temperature
°F
 
Processing (Melt) Temp
°F
 
Mold Temperature
°F
 
Injection Pressure
psi
 
Injection Rate
 
 
Back Pressure
psi
 
Injection Notes
Avoid excessive melt temperatures and long residence times as this could lead to thermal degradation.
Notes
1Typical properties: these are not to be construed as specifications.
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.