IDES Prospector Already have an account? Login Here

IDES

ICORENE® 3560 S6

Linear Low Density Polyethylene

Supplied by ICO Polymers, Inc.

The technical datasheet with complete property values for ICORENE® 3560 S6 is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
Product Description
ICORENE® 3560 S6 is a polyethylene developed for rotational molding applications. Intended applications are primarily large hollow objects, including toys, playground equipment, drums and agricultural and chemical storage containers and a variety of products. The resin is fully UV stabilized. Base resin is FDA approved however specific limitations or conditions of use may apply.
General  
Material Status 
  • Commercial: Active
Availability 
  • North America
Additive 
  • UV Stabilizer
Features 
  • Good UV Resistance
  • High ESCR (Stress Crack Resist.)
  • Low Temperature Impact Resistance
  • Warp Resistant
  
Uses 
  • Agricultural Applications
  • Drums
  • Toys
Agency Ratings 
Appearance 
  • Black
  • Colors Available
  
Forms 
  • Powder
Processing Method 
  • Rotational Molding
Physical
Nominal Value
Unit
Test Method
Density
g/cm³
 ASTM D1505
Melt Mass-Flow Rate (MFR) (190°C/2.16 kg)
g/10 min
 ASTM D1238
Environmental Stress-Cracking Resistance
     ASTM D1693
10% Igepal, F50
hr
  
100% Igepal, F50
hr
  
Mechanical
Nominal Value
Unit
Test Method
Tensile Strength 2 (Yield)
psi
 ASTM D638
Flexural Modulus
psi
 ASTM D790
Thermal
Nominal Value
Unit
Test Method
Deflection Temperature Under Load
     ASTM D648
66 psi, Unannealed
°F
  
264 psi, Unannealed
°F
  
Additional Information
Low Temperature Impact, ARM STD, 0.125 in: 45 ft-lbs
Low Temperature Impact, ARM STD, 0.125 in, -40°F: 150 ft-lbs
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: ICORENE® 3560 S6, ICORENE 3560 S6, ICORENE® , ICORENE, ICORENE3560S6, 3560 S 6, 3560 S6, 3560S, S6, 3560S6, Polyethylene, Linear Low Density, Polyethylene Linear Low Density, LLDPE, Polyethylene, PE, ICO Polymers, PolyethyleneLinearLowDensity, S3560
Features
Features may also be described by the following terms: Warp Resistant, Warpage Resistant, Good UV Resistance, UV Resistant, Ultraviolet Resistant, Ultraviolet Light Resistant, Low Temperatuer Impact Resistance, Low Temp Impact Resistance, High Environmental Stress Cracking Resistance, High ESCR, Stress Cracking Resistant.
Agency Ratings
This plastic material has 1 certifications from the following agencies (the number in parentheses shows the number of certifications for that agency): FDA (1).
Notes
1Typical properties: these are not to be construed as specifications.
2Type IV, 2.0 in/min
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.