IDES Prospector Already have an account? Login Here

IDES

ICORENE® 4420 S1

High Density Polyethylene

Supplied by ICO Polymers, Inc.

The technical datasheet with complete property values for ICORENE® 4420 S1 is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
Product Description
ICORENE® 4420 S1 is a hexane polyethylene developed for rotational molding. Intended applications are large rotationally molded tanks. The resin is fully UV stabilized. Base resin is FDA approved.
General  
Material Status 
  • Commercial: Active
Availability 
  • North America
Additive 
  • UV Stabilizer
Features 
  • Good Impact Resistance
  • Good Stiffness
  • Good UV Resistance
  • Hexene Comonomer
  • Low Warpage
Uses 
  • Tanks
Agency Ratings 
Appearance 
  • Black
  • Colors Available
  
Forms 
  • Powder
Processing Method 
  • Rotational Molding
Physical
Nominal Value
Unit
Test Method
Density
g/cm³
 ASTM D1505
Melt Mass-Flow Rate (MFR) (190°C/2.16 kg)
g/10 min
 ASTM D1238
Environmental Stress-Cracking Resistance
     ASTM D1693
10% Igepal CO-630, F50
hr
  
100% Igepal CO-630, F50
hr
  
Mechanical
Nominal Value
Unit
Test Method
Tensile Strength 2 (Yield)
psi
 ASTM D638
Flexural Modulus
psi
 ASTM D790
Thermal
Nominal Value
Unit
Test Method
Deflection Temperature Under Load
     ASTM D648
66 psi, Unannealed
°F
  
264 psi, Unannealed
°F
  
Additional Information
Low Temperature Impact, ARM STD, 0.125 in: 48 ft-lbs
Low Temperature Impact, ARM STD, 0.125 in, -40°F: 145 ft-lbs
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: ICORENE® 4420 S1, ICORENE 4420 S1, ICORENE® , ICORENE, ICORENE4420S1, 4420 S 1, 4420 S1, 4420S, S1, 4420S1, Polyethylene, High Density, Polyethylene High Density, HDPE, Polyethylene, PE, ICO Polymers, PolyethyleneHighDensity, S4420
Features
Features may also be described by the following terms: Low Warpage, Low Warp, Good UV Resistance, UV Resistant, Ultraviolet Resistant, Ultraviolet Light Resistant, Good Stiffness, Good Impact Resistance, Hexene Comonomer.
Agency Ratings
This plastic material has 1 certifications from the following agencies (the number in parentheses shows the number of certifications for that agency): FDA (1).
Notes
1Typical properties: these are not to be construed as specifications.
2Type IV, 2.0 in/min
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.