IDES Prospector Already have an account? Login Here

IDES

SUMILITE® PL-1108T

Phenolic

Supplied by Sumitomo Bakelite Co., Ltd.

The technical datasheet with complete property values for SUMILITE® PL-1108T is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
General  
Material Status 
  • Commercial: Active
Availability 
  • North America
Features 
  • Good Dimensional Stability
Uses 
  • Laminates
Appearance 
  • Natural Color
Forms 
  • Pellets
Physical
Nominal Value
Unit
Test Method
Specific Gravity
 
 ASTM D792
Water Absorption (73°F, 24 hr)
%
 ASTM D570
Mechanical
Nominal Value
Unit
Test Method
Tensile Strength (Yield)
psi
 ASTM D638
Flexural Strength (Yield)
psi
 ASTM D790
Compressive Strength
psi
 ASTM D695
Impact
Nominal Value
Unit
Test Method
Notched Izod Impact
     ASTM D256
Across Flow
ft·lb/in
  
Flow
ft·lb/in
  
Electrical
Nominal Value
Unit
Test Method
Dielectric Strength
V/mil
 ASTM D149
Additional Information
Tests were performed in accordance with JIS K6911
Flexural Strength, JIS K6911, Flow: 110 Mpa
Flexural Strength, JIS K6911, Accross Flow: 100 Mpa
Tensile Strength at Yield, JIS K6911, Flow: 90 Mpa
Tensile Strength at Yield, JIS K6911, Accross Flow: 90 Mpa
Compressive Strength, JIS K6911, Vertical: 220 Mpa
Compressive Strength, JIS K6911, Parallel: 130 Mpa
Bonding Strength, JIS K6911: 4.9 KN
Solvent Resistivity, JIS K6911, 30 min boil: Constant
Dielectric Strength, JIS K6911, Flatwise: 18 MV/m
Dielectric Strength, JIS K6911, Edgewise: 14 KV
Insulation Resistance, JIS K6911: 1e4 M ohms
Insulation Resistance JIS K6911: 1e2 M ohms
Heat Resistivity, JIS K6911, 120 min: 130°C
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: SUMILITE® PL-1108T, SUMILITE PL1108T, SUMILITE® , SUMILITE, SUMILITEPL1108T, PL, PL 1108 T, PL-1108T, PL1108T, PL:1108T, PL/1108T, PL+1108T, PL_1108T, PL 1108T, PL1108, 1108T, Phenolic, Sumitomo Bake, 1108PL
Features
Features may also be described by the following terms: Good Dimensional Stability, Dimensionally Stable.
Notes
1Typical properties: these are not to be construed as specifications.
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.