IDES Prospector Already have an account? Login Here

IDES

Radici Compounds N602L

Polyamide 6

Supplied by Radici Plastics USA, Inc.

The technical datasheet with complete property values for Radici Compounds N602L is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
General  
Material Status 
  • Commercial: Active
Availability 
  • North America
Additive 
  • Lubricant
Features 
  • Good Chemical Resistance
  • Good Flexibility
  • Good Melt Strength
  • Good Toughness
  • Lubricated
Forms 
  • Pellets
Processing Method 
  • Extrusion
Physical
Nominal Value
Unit
Test Method
Specific Gravity
 
 ASTM D792
Water Absorption (24 hr)
%
 ASTM D570
Mechanical
Nominal Value
Unit
Test Method
Tensile Strength (Yield, 73°F)
psi
 ASTM D638
Tensile Elongation (Break, 73°F)
%
 ASTM D638
Flexural Modulus (73°F)
psi
 ASTM D790
Flexural Strength (73°F)
psi
 ASTM D790
Impact
Nominal Value
Unit
Test Method
Notched Izod Impact (73°F, 0.125 in)
ft·lb/in
 ASTM D256
Thermal
Nominal Value
Unit
Test Method
Deflection Temperature Under Load (264 psi, Unannealed)
°F
 ASTM D648
Melting Temperature
°F
 ASTM D789
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: Radici Compounds N602L, Radici Compounds , RadiciCompoundsN602L, RadiciCompounds, CompoundsN 602 L, CompoundsN602L, CompoundsN602, Compounds, N 602 L, N602L, N602, 602L, Polyamide 6, Nylon 6, Polyamide, Nylon, pa6, Radici USA, Polyamide6, Nylon6, 602N, 602CompoundsN
Generic Name
Generic Name may also be described by the following terms: PA6.
Features
Features may also be described by the following terms: Good Toughness, Tough, Good Melt Strength, Good Flexibility, Flexible, Good Chemical Resistance, Chemical Resistant.
Extrusion
Nominal Value
Unit
 
Drying Temperature
°F
  
Suggested Max Moisture
%
  
Cylinder Zone 1 Temp.
°F
  
Cylinder Zone 3 Temp.
°F
  
Cylinder Zone 5 Temp.
°F
  
Melt Temperature
°F
  
Die Temperature
°F
  
Extrusion Notes
Flange Temperature: 440 to 470°F
Head Temperature: 440 to 470°F
L/D Ratio: 20:1 to 24:1
Compression Ratio: 3.5:1 to 4.0:1
Metering Secion: 40% of Screw Flights
Transition Section: 6 to 7 Flights
Feed Section: Balance of Screw Flights
Notes
1Typical properties: these are not to be construed as specifications.
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.