IDES Prospector Already have an account? Login Here

IDES

Network Polymers PP PPR 20 3401 CAS

Polypropylene Random Copolymer

Supplied by Network Polymers, Inc.

The technical datasheet with complete property values for Network Polymers PP PPR 20 3401 CAS is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
General  
Material Status 
  • Commercial: Active
Availability 
  • North America
Additive 
  • Antistatic
  • Clarifier
  • Nucleating Agent
Features 
  • Antistatic
  • Fast Molding Cycle
  • Food Contact Acceptable
  • Good Toughness
  • Low Warpage
  • Nucleated
Uses 
  • Thin-walled Parts
Agency Ratings 
Processing Method 
  • Injection Molding
Physical
Nominal Value
Unit
Test Method
Specific Gravity
 
 ASTM D792
Melt Mass-Flow Rate (MFR) 2 (230°C/2.16 kg)
g/10 min
 ASTM D1238
Mechanical
Nominal Value
Unit
Test Method
Tensile Strength 3 (Yield)
psi
 ASTM D638
Tensile Elongation 3 (Yield)
%
 ASTM D638
Flexural Modulus 4
psi
 ASTM D790B
Impact
Nominal Value
Unit
Test Method
Notched Izod Impact (0.125 in)
ft·lb/in
 ASTM D256A
Thermal
Nominal Value
Unit
Test Method
Deflection Temperature Under Load (66 psi, Unannealed)
°F
 ASTM D648
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: Network Polymers PP PPR 20 3401 CAS, Network Polymers PP , NetworkPolymersPPPPR203401CAS, NetworkPolymersPP, PPPPR 20 3401 CAS, PPPPR20, PP, PPPPR203401CAS, PPR 20 3401 CAS, PPR20, 203401, 3401CAS, PPR203401CAS, Polypropylene Random Copolymer, PP Random Copolymer, Polypropylene, Network Poly, PolypropyleneRandomCopolymer, PPRandomCopolymer, 20PPR, 20PPPPR
Features
Features may also be described by the following terms: Fast Cycle, Rapid Cycle, Productivity, Fast Molding Cycle, Low Warpage, Low Warp, Good Toughness, Tough.
Uses
Uses may also be described by the following terms: Thin-walled Parts, Thin Walled Parts, Thin-wall Parts, Thin wall Parts, Thinwall Parts.
Agency Ratings
This plastic material has 1 certifications from the following agencies (the number in parentheses shows the number of certifications for that agency): FDA (1).
Notes
1Typical properties: these are not to be construed as specifications.
2Procedure A
32.0 in/min
4Method I (3 point load), 0.050 in/min
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.