IDES Prospector Already have an account? Login Here

IDES

Arnite® A02 306

Polyethylene Terephthalate

Supplied by DSM Engineering Plastics

The technical datasheet with complete property values for Arnite® A02 306 is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
General  
Material Status 
  • Commercial: Active
Availability 
  • Europe
Features 
  • Low Viscosity
RoHS Compliance 
Appearance 
  • Clear/Transparent
Forms 
  • Pellets
Processing Method 
  • Extrusion
Physical
Nominal Value
Unit
Test Method
Density      
--
g/cm³
 ISO 1183
--
lb/in³
 ISO 1183 2
Water Absorption      
Equilibrium, 73°F, 50% RH
%
 ISO 62
Equilibrium
%
 ISO 62 2
Thermal
Nominal Value
Unit
Test Method
Melting Temperature      
-- 3
°F
 ISO 11357-3
-- 4
°F
 ISO 11357-3 2
Thermal Conductivity 5
Btu·in/hr/ft²/°F
  
Electrical
Nominal Value
Unit
Test Method
Surface resistivity
ohms
 IEC 60093 2
Volume resistivity
ohm·in
 IEC 60093 2
Fill Analysis
Nominal Value
Unit
Test Method
Specific Heat Capacity of Melt
Btu/lb/°F
  
Additional Information
Nominal Value
Unit
Test Method
RSV 6
 
 Internal Method
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: Arnite® A02 306, Arnite A02 306, Arnite® , Arnite, ArniteA02306, A 02 306, A02 306, A02, 02306, A02306, Polyethylene Terephthalate, PET, Polyester, DSM EP, PolyethyleneTerephthalate, 02A
Features
Features may also be described by the following terms: Low Viscosity.
Injection
Nominal Value
Unit
 
Drying Temperature
°F
  
Drying Time
hr
  
Suggested Max Moisture
%
  
Rear Temperature
°F
  
Middle Temperature
°F
  
Front Temperature
°F
  
Nozzle Temperature
°F
  
Processing (Melt) Temp
°F
  
Mold Temperature
°F
  
Notes
1Typical properties: these are not to be construed as specifications.
2Tested in accordance with ISO 10350. 23°C/50%r.h. unless otherwise noted.
310°C/min
418 °F/min
5Of melt
6m-cresol, 1g/100ml
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.