J-REX LD JF324S JPO Polyethylene, Low Density

General

Material Status

Commercial: Active

Availability

Asia Pacific

North America

Features

Low Density

Uses

Film

Forms

Pellets

Physical	Nominal Value	Unit	Test Method
Specific Gravity			ASTM D792
Melt Mass-Flow Rate (MFR) (190°C/2.16 kg)		g/10 min	ASTM D1238
Mechanical	Nominal Value	Unit	Test Method
Tensile Strength			ASTM D638
Yield		psi
Break		psi
Tensile Elongation (Break)		%	ASTM D638
Flexural Strength (Yield)		psi	ASTM D790
Films	Nominal Value	Unit	Test Method
Tensile Strength			ASTM D882
MD: Break, 1.2 mil		psi
TD: Break, 1.2 mil		psi
Tensile Elongation			ASTM D882
MD: Break, 1.2 mil		%
TD: Break, 1.2 mil		%
Elmendorf Tear Strength			ASTM D1922
MD: 1.2 mil		g
TD: 1.2 mil		g
Hardness	Nominal Value	Unit	Test Method
Durometer Hardness (Shore D)			ASTM D2240
Thermal	Nominal Value	Unit	Test Method
Brittleness Temperature		°F	ASTM D746
Vicat Softening Temperature		°F	ASTM D1525
Melting Temperature		°F	DSC
Optical	Nominal Value	Unit	Test Method
Gloss (60°)			ASTM D2457
Haze		%	ASTM D1003
Additional Information
Most properties were tested in accordance with JIS test standards Coefficient of Dynamic Friction Outer-Outer, ASTM D1894: 0.1 Film Impact, JIS P 8134: 24 J/mm
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: J-REX LD JF324S, JREX LD JF324S, J-REX LD , JREX LD, J:REX LD, J/REX LD, J+REX LD, J_REX LD, J REX LD, JREXLDJF324S, JREXLD, LDJF 324 S, J_REXLD, LDJF324S, LDJF324, LD, JF 324 S, JF324S, JF324, 324S, Polyethylene, Low Density, Polyethylene Low Density, LDPE, Polyethylene, PE, JPO, PolyethyleneLowDensity, 324JF, 324LDJF
Features
Features may also be described by the following terms: Low Density, Low Specific Gravity.

Notes

¹Typical properties: these are not to be construed as specifications.

J-REX LD JF324S

Low Density Polyethylene

Supplied by Japan Polyolefins Co., Ltd. (JPO)