IDES Prospector Already have an account? Login Here

IDES

HARMOREX-LL NC524A

Linear Low Density Polyethylene

Supplied by Japan Polyolefins Co., Ltd. (JPO)

The technical datasheet with complete property values for HARMOREX-LL NC524A is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
General  
Material Status 
  • Commercial: Active
Availability 
  • Asia Pacific
  • North America
  
Features 
  • Low Density
Uses 
  • Cups
  • Film
  
Forms 
  • Pellets
Processing Method 
  • Blown Film
Physical
Nominal Value
Unit
Test Method
Specific Gravity
 
 ASTM D792
Melt Mass-Flow Rate (MFR) (190°C/2.16 kg)
g/10 min
 ASTM D1238
Mechanical
Nominal Value
Unit
Test Method
Tensile Strength
     ASTM D638
Yield
psi
  
Break
psi
  
Tensile Elongation (Break)
%
 ASTM D638
Flexural Strength (Yield)
psi
 ASTM D790
Films
Nominal Value
Unit
Test Method
Secant Modulus
     ASTM D882
MD: 1.2 mil
psi
  
TD: 1.2 mil
psi
  
Tensile Strength
     ASTM D882
MD: Break, 1.2 mil
psi
  
TD: Break, 1.2 mil
psi
  
Tensile Elongation
     ASTM D882
MD: Break, 1.2 mil
%
  
TD: Break, 1.2 mil
%
  
Elmendorf Tear Strength
     ASTM D1922
MD: 1.2 mil
g
  
TD: 1.2 mil
g
  
Impact
Nominal Value
Unit
Test Method
Tensile Impact Strength
ft·lb/in²
 ASTM D1822
Hardness
Nominal Value
Unit
Test Method
Durometer Hardness (Shore D)
 
 ASTM D2240
Thermal
Nominal Value
Unit
Test Method
Brittleness Temperature
°F
 ASTM D746
Vicat Softening Temperature
°F
 ASTM D1525
Optical
Nominal Value
Unit
Test Method
Gloss (60°)
 
 ASTM D2457
Haze
%
 ASTM D1003
Additional Information
Most properties were tested in accordance with JIS test standards
Film Impact, JIS P 8134: 69 J/mm
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: HARMOREX-LL NC524A, HARMOREXLL NC524A, HARMOREX-LL , HARMOREXLL, HARMOREX:LL, HARMOREX/LL, HARMOREX+LL, HARMOREX_LL, HARMOREX LL, HARMOREXLLNC524A, NC 524 A, NC524A, NC524, 524A, Polyethylene, Linear Low Density, Polyethylene Linear Low Density, LLDPE, Polyethylene, PE, JPO, PolyethyleneLinearLowDensity, 524NC
Features
Features may also be described by the following terms: Low Density, Low Specific Gravity.
Notes
1Typical properties: these are not to be construed as specifications.
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.