IDES Prospector Already have an account? Login Here

IDES

REXPEARL ET234M

Polyolefin

Supplied by Japan Polyolefins Co., Ltd. (JPO)

The technical datasheet with complete property values for REXPEARL ET234M is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
General  
Material Status 
  • Commercial: Active
Availability 
  • Asia Pacific
  • North America
  
Features 
  • Good Adhesion
  • Good Melt Strength
  • Low Viscosity
  • Terpolymer
  
Forms 
  • Pellets
Processing Method 
  • Extrusion Coating
  • Injection Molding
  
Physical
Nominal Value
Unit
Test Method
Specific Gravity
 
 ASTM D792
Melt Mass-Flow Rate (MFR) (190°C/2.16 kg)
g/10 min
 ASTM D1238
Mechanical
Nominal Value
Unit
Test Method
Tensile Strength (Break)
psi
 ASTM D638
Tensile Elongation (Break)
%
 ASTM D638
Flexural Modulus
psi
 ASTM D790
Hardness
Nominal Value
Unit
Test Method
Durometer Hardness (Shore D)
 
 ASTM D2240
Thermal
Nominal Value
Unit
Test Method
Vicat Softening Temperature
°F
 ASTM D1525
Melting Temperature
°F
 DSC
Peak Crystallization Temperature (DSC)
°F
 ASTM D3418
Additional Information
Most properties were tested in accordance with JIS test standards
Comonomer: ter-polymer
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: REXPEARL ET234M, REXPEARL , REXPEARLET234M, ET 234 M, ET234M, ET234, 234M, Polyolefin, Unspecified, Polyolefin Unspecified, Polyolefin, JPO, PolyolefinUnspecified, 234ET
Features
Features may also be described by the following terms: Low Viscosity, Good Melt Strength, Good Adhesion.
Notes
1Typical properties: these are not to be construed as specifications.
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.