IDES Prospector Already have an account? Login Here

IDES

OLEFLEX P132G

Thermoplastic Polyolefin Elastomer

Supplied by Japan Polyolefins Co., Ltd. (JPO)

The technical datasheet with complete property values for OLEFLEX P132G is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
General  
Material Status 
  • Commercial: Active
Availability 
  • Asia Pacific
  • North America
  
Features 
  • Low Hardness
Forms 
  • Pellets
Processing Method 
  • Injection Molding
Physical
Nominal Value
Unit
Test Method
Specific Gravity
 
 ASTM D792
Melt Mass-Flow Rate (MFR) (230°C/2.16 kg)
g/10 min
 ASTM D1238
Elastomers
Nominal Value
Unit
Test Method
Tensile Stress 2 (100% Strain)
psi
 ASTM D412
Tensile Strength 2 (Break)
psi
 ASTM D412
Tensile Elongation 2 (Break)
%
 ASTM D412
Compression Set
     ASTM D395
73°F, 22.0 hr
%
  
163°F, 22.0 hr
%
  
Impact
Nominal Value
Unit
Test Method
Notched Izod Impact Strength
     ISO 180
-22°F
 
  
73°F
 
  
Hardness
Nominal Value
Unit
Test Method
Durometer Hardness (Shore D)
 
 ASTM D2240
Additional Information
Most properties were tested in accordance with JIS test standards
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: OLEFLEX P132G, OLEFLEX , OLEFLEXP132G, P 132 G, P132G, P132, 132G, TPO, Thermoplastic Polyolefin Elastomer, TPO (POE), TPO POE, Thermoplastic Elastomer, TPE, JPO, ThermoplasticPolyolefinElastomer, TPOPOE, ThermoplasticElastomer, 132P
Features
Features may also be described by the following terms: Low Hardness.
Notes
1Typical properties: these are not to be construed as specifications.
27.9 in/min
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.