IDES Prospector Already have an account? Login Here

IDES

DINALON® PA 6 30% CM

Polyamide 6

Mineral Filler, 30%

Supplied by Grupo Repol

The technical datasheet with complete property values for DINALON® PA 6 30% CM is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
General  
Material Status 
  • Commercial: Active
Availability 
  • Europe
Filler / Reinforcement 
  • Mineral Filler, 30% Filler by Weight
Forms 
  • Pellets
Processing Method 
  • Injection Molding
Physical
Nominal Value
Unit
Test Method
Specific Gravity
 
 ASTM D792
Molding Shrinkage - Flow
in/in
 ASTM D955
Mechanical
Nominal Value
Unit
Test Method
Tensile Strength
psi
 ASTM D638
Tensile Elongation (Break)
%
 ASTM D638
Flexural Modulus
psi
 ASTM D790
Flexural Strength
psi
 ASTM D790
Impact
Nominal Value
Unit
Test Method
Unnotched Izod Impact
ft·lb/in
 ASTM D256
Thermal
Nominal Value
Unit
Test Method
Vicat Softening Temperature
°F
 ASTM D1525
Flammability
Nominal Value
Unit
Test Method
Flame Rating - UL
 
 UL 94
Additional Information
Glow Wire, UNE 20-672-83: 650°C
Vicat Softening Temperature, ASTM D1525: >190°C
DTUL, ASTM D648: 110°C
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: DINALON® PA 6 30% CM, DINALON PA 6 30 CM, DINALON® , DINALON, DINALONPA630CM, PA 6 30% CM, PA 6 30 CM, PA6, 630, 30CM, PA630CM, Polyamide 6, Nylon 6, Polyamide, Nylon, Grupo Repol, Polyamide6, Nylon6, 6PA
Generic Name
Generic Name may also be described by the following terms: PA6.
Injection
Nominal Value
Unit
 
Processing (Melt) Temp
°F
  
Mold Temperature
°F
  
Notes
1Typical properties: these are not to be construed as specifications.
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.