VAMPTER 1026 V0 Vamp Tech Polybutylene Terephthalate (Glass Fiber Reinforcement, 10%)

Product Description
UL 94 V0, 10% glass fibre reinforced
General
Material Status	Commercial: Active
Availability	Europe
Filler / Reinforcement	Glass Fiber Reinforcement, 10% Filler by Weight
RoHS Compliance
Forms	Pellets

Physical	Nominal Value	Unit	Test Method
Specific Gravity
--			ASTM D792
--		g/cm³	ISO 1183
Molding Shrinkage - Flow		in/in	ASTM D955
Water Absorption (24 hr)		%	ASTM D570
Mechanical	Nominal Value	Unit	Test Method
Tensile Strength (Yield)		psi	ASTM D638, ISO 527-2
Tensile Elongation (Yield)		%	ASTM D638, ISO 527-2
Flexural Modulus		psi	ASTM D790, ISO 178
Flexural Strength
--		psi	ISO 178
Yield		psi	ASTM D790
Impact	Nominal Value	Unit	Test Method
Charpy Unnotched Impact Strength		ft·lb/in²	ISO 179
Notched Izod Impact Strength		ft·lb/in²	ISO 180
Thermal	Nominal Value	Unit	Test Method
Deflection Temperature Under Load
66 psi, Unannealed		°F	ASTM D648, ISO 75-2/B
264 psi, Unannealed		°F	ASTM D648, ISO 75-2/A
Vicat Softening Temperature
--		°F	ASTM D1525², ISO 306/A50²
--		°F	ASTM D1525³, ISO 306/B50³
CLTE - Flow		in/in/°F	ASTM D696
Electrical	Nominal Value	Unit	Test Method
Surface Resistivity		ohms	ASTM D257
Volume Resistivity		ohm·cm	ASTM D257
Dielectric Strength		V/mil	ASTM D149
Comparative Tracking Index			IEC 60112
Solution A		V
Solution B		V
Needle Flame Test			IEC 60695-11-5
Flammability	Nominal Value	Unit	Test Method
Flame Rating - UL			UL 94
0.0315 in
0.0630 in
0.126 in
Glow Wire Ignition Temperature		°F	IEC 60695-2-13
Oxygen Index		%	ASTM D2863
Additional Information
Ball Penetration Test, IEC 335, 125 °C: Yes Ball Penetration Test, IEC 335, 165 °C: Yes Flame Resistance. CSA C22-2: Yes Operating Temperature Limit: 170°C Operating Temperature, IEC 216: 130°C
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: VAMPTER 1026 V0, VAMPTER , VAMPTER1026V0, 1026 V 0, 1026 V0, 1026V, V0, 1026V0, Polybutylene Terephthalate, PBT, Polyester, Vamp Tech, PolybutyleneTerephthalate, V1026

Injection	Nominal Value	Unit
Drying Temperature		°F
Drying Time		hr
Rear Temperature		°F
Mold Temperature		°F

Notes

¹Typical properties: these are not to be construed as specifications.

²Rate A (50°C/h)

³Rate B (120°C/h)

VAMPTER 1026 V0

Polybutylene Terephthalate

Glass Fiber Reinforcement, 10%

Supplied by Vamp Tech