SABIC LLDPE 6318BE SABIC Polyethylene, Linear Low Density

General

Material Status

Availability

Features

Uses

Forms

Processing Method

Physical	Nominal Value	Unit	Test Method
Density		g/cm³	ISO 1183/A
Melt Mass-Flow Rate (MFR) (190°C/2.16 kg)		g/10 min	ISO 1133
Films	Nominal Value	Unit	Test Method
Film Thickness - Tested		mil
Secant Modulus			ASTM D882
MD: 1.2 mil		psi
TD: 1.2 mil		psi
Tensile Strength			ASTM D882
MD: Yield, 1.2 mil		psi
TD: Yield, 1.2 mil		psi
MD: Break, 1.2 mil		psi
TD: Break, 1.2 mil		psi
Tensile Elongation			ASTM D882
MD: Break, 1.2 mil		%
TD: Break, 1.2 mil		%
Dart Drop Impact (1.2 mil, Blown Film)		g	ASTM D1709
Elmendorf Tear Strength			ASTM D1922
MD: 1.2 mil		g
TD: 1.2 mil		g
Optical	Nominal Value	Unit	Test Method
Gloss (60°, 1.18 mil, Blown Film)			ASTM D2457
Haze (1.18 mil, Blown Film)		%	ASTM D1003
Additional Information
30µm blown film produced with a blow up ratio of 2.5. Puncture Resistance, SABIC Method, 30µm, Blown Film: 64 J/mm
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: SABIC® LLDPE 6318BE, SABIC LLDPE 6318BE, SABIC® LLDPE , SABIC LLDPE, SABICLLDPE6318BE, SABICLLDPE, LLDPE 6318 BE, LLDPE6318BE, LLDPE6318, LLDPE, 6318 BE, 6318BE, Polyethylene, Linear Low Density, Polyethylene Linear Low Density, Polyethylene, PE, SABIC, PolyethyleneLinearLowDensity, BE6318, 6318LLDPE
Features
Features may also be described by the following terms: Good Toughness, Tough, Good Thermal Stability, Good Tear Strength, Good Puncture Resistance, Puncture Resistant.
Uses
Uses may also be described by the following terms: Stretch Wrap, Cast Film.

Extrusion	Nominal Value	Unit
Melt Temperature		°F

Notes

¹Typical properties: these are not to be construed as specifications.

SABIC® LLDPE 6318BE