IDES Prospector Already have an account? Login Here

IDES

Braskem PP 5E89

Polypropylene Homopolymer

Supplied by Braskem America Inc.

The technical datasheet with complete property values for Braskem PP 5E89 is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
Product Description
Braskem 5E89 PolyPropylene Resin is intended for use in stretched tape (raffia) processes, from which the raffia is used to produce woven fabrics for carpet backing, sacking, industrial and geotextile applications.

Main Characteristics:
  • Consistent processability
  • Good color stability
  • High strength properties
  • Low water "carry-over"
  • High speed processing

Complies with:
  • U.S. FDA 21 CFR 177.1520 (c) 1.1a.
  • Canadian HPFB No Objection
Consult the regulations for complete details.
General  
Material Status 
  • Commercial: Active
Availability 
  • Asia Pacific
  • Latin America
  • North America
Agency Ratings 
 
Forms 
  • Pellets
Processing Method 
  • Cast Film
Physical
Nominal Value
Unit
Test Method
Specific Gravity
 
 ASTM D792
Melt Mass-Flow Rate (MFR) (230°C/2.16 kg)
g/10 min
 ASTM D1238
Mechanical
Nominal Value
Unit
Test Method
Tensile Strength 2 (Yield)
psi
 ASTM D638
Tensile Elongation 2 (Yield)
%
 ASTM D638
Flexural Modulus - 1% Secant 2
psi
 ASTM D790A
Impact
Nominal Value
Unit
Test Method
Notched Izod Impact 2 (73°F)
ft·lb/in
 ASTM D256A
Hardness
Nominal Value
Unit
Test Method
Rockwell Hardness 2 (R-Scale)
 
 ASTM D785
Thermal
Nominal Value
Unit
Test Method
Deflection Temperature Under Load 2 (66 psi, Unannealed)
°F
 ASTM D648
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: Braskem PP 5E89, Braskem PP , BraskemPP5E89, BraskemPP, PP 5 E 89, PP5E89, PP5, PP, 5 E 89, 5E89, 5E, E89, Polypropylene Homopolymer, PP Homopolymer, Polypropylene, PolypropyleneHomopolymer, PPHomopolymer, E5, 5PP
Agency Ratings
This plastic material has 2 certifications from the following agencies (the number in parentheses shows the number of certifications for that agency): FDA (1), HPFB (Canada) (1).
Notes
1Typical properties: these are not to be construed as specifications.
2Testing performed on ASTM D 638 Type I specimen, molded and tested in accordance with ASTM D 4101. Properties will vary with changes in molding conditions and aging time.
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.