IDES Prospector Already have an account? Login Here

IDES

SABIC® HDPE B4660AB

High Density Polyethylene

Supplied by Saudi Basic Industries Corporation (SABIC)

The technical datasheet with complete property values for SABIC® HDPE B4660AB is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
General  
Material Status 
  • Commercial: Active
Availability 
  • Europe
Features 
  • Food Contact Acceptable
  • Good Processability
  • Good Toughness
  • High Rigidity
  
Uses 
  • Blow Molding Applications
  • Bottles
  • Profiles
Forms 
  • Pellets
Processing Method 
  • Blow Molding
  • Profile Extrusion
  
Physical
Nominal Value
Unit
Test Method
Density
g/cm³
 ASTM D1505
Melt Mass-Flow Rate (MFR)
     ASTM D1238
190°C/2.16 kg
g/10 min
  
190°C/21.6 kg
g/10 min
  
Environmental Stress-Cracking Resistance (100% Igepal, Compression Molded, F50)
hr
 ASTM D1693B
Mechanical
Nominal Value
Unit
Test Method
Tensile Modulus - 1% Secant (Compression Molded)
psi
 ASTM D638
Tensile Strength
     ASTM D638
Yield, Compression Molded
psi
  
Break, Compression Molded
psi
  
Tensile Elongation (Break, Compression Molded)
%
 ASTM D638
Impact
Nominal Value
Unit
Test Method
Notched Izod Impact (Compression Molded)
ft·lb/in
 ASTM D256
Hardness
Nominal Value
Unit
Test Method
Durometer Hardness (Shore D, Compression Molded)
 
 ASTM D2240
Thermal
Nominal Value
Unit
Test Method
Brittleness Temperature
°F
 ASTM D746
Vicat Softening Temperature
°F
 ASTM D1525 2
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: SABIC® HDPE B4660AB, SABIC HDPE B4660AB, SABIC® HDPE , SABIC HDPE, SABICHDPEB4660AB, SABICHDPE, HDPEB 4660 AB, HDPEB4660AB, HDPEB4660, HDPE, B 4660 AB, B4660AB, B4660, 4660AB, Polyethylene, High Density, Polyethylene High Density, Polyethylene, PE, SABIC, PolyethyleneHighDensity, 4660B, 4660HDPEB
Features
Features may also be described by the following terms: Good Processability, Easy Processing, Good Toughness, Tough, High Rigidity.
Extrusion
Nominal Value
Unit
 
Cylinder Zone 1 Temp.
°F
  
Melt Temperature
°F
  
Notes
1Typical properties: these are not to be construed as specifications.
2Loading 1 (10 N)
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.