IDES Prospector Already have an account? Login Here

IDES

ALAMID® 6 V0

Polyamide 6

Supplied by LEIS Polytechnik - polymere Werkstoffe GmbH

The technical datasheet with complete property values for ALAMID® 6 V0 is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
General  
Material Status 
  • Commercial: Active
Availability 
  • Europe
Features 
  • Flame Retardant
Forms 
  • Pellets
Physical
Nominal Value
Unit
Test Method
Density
g/cm³
ISO 1183
Molding Shrinkage
%
ISO 294-4
Mechanical
Nominal Value
Unit
Test Method
Tensile Modulus
psi
ISO 527-2
Tensile Stress (Yield)
psi
ISO 527-2
Tensile Strain (Break)
%
ISO 527-2
Impact
Nominal Value
Unit
Test Method
Charpy Unnotched Impact Strength
ft·lb/in²
ISO 179/1eU
Thermal
Nominal Value
Unit
Test Method
Heat Deflection Temperature (264 psi, Unannealed)
°F
ISO 75-2/A
Melting Temperature (DSC)
°F
ISO 3146
Electrical
Nominal Value
Unit
Test Method
Comparative Tracking Index
V
IEC 60112
Flammability
Nominal Value
Unit
Test Method
Flame Rating - UL (0.126 in)
 
UL 94
Glow Wire Ignition Temperature (0.0787 in)
°F
IEC 60695-2-13
Additional Information
Tensile Strain at Break, ISO 527-1-2: >5%
Heat resistance, IEC 89, Ball Compression: 125°C
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: ALAMID® 6 V0, ALAMID 6 V0, ALAMID® , ALAMID, ALAMID6V0, 6 V 0, 6 V0, 6V, V0, 6V0, Polyamide 6, Nylon 6, Polyamide, Nylon, pa6, Leis Polytechnik, Polyamide6, Nylon6, V6
Generic Name
Generic Name may also be described by the following terms: PA6.
Notes
1Typical properties: these are not to be construed as specifications.
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.