IDES Prospector Already have an account? Login Here

IDES

ALKAMIX™ MB6002

Linear Low Density Polyethylene

Supplied by Qenos Pty Ltd

The technical datasheet with complete property values for ALKAMIX™ MB6002 is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
Product Description
ALKAMIX MB6002 is formulated with an antiblock additive at a concentration of 25 percent.

ALKAMIX MB6002 can be added to polyethylene during extrusion to reduce the blocking tendency of film. The level required may vary according to desired properties, however the recommended addition level is between 1 to 3 percent.

The maximum level of addition of MB6002 based on both good manufacturing practice and to ensure conformance to the requirements to the United States Food and Drug Administration Regulations CFR21 is 4 percent, when added to a polyethylene formulation free of any other additives.
General  
Material Status 
  • Commercial: Active
Availability 
  • Asia Pacific
Additive 
  • Antiblock (250000 ppm)
Features 
  • Antiblocking
  • High Clarity
  
Uses 
  • Blending
Forms 
  • Pellets
Physical
Nominal Value
Unit
Test Method
Density
g/cm³
 ASTM D1505
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: ALKAMIX™ MB6002, ALKAMIX MB6002, ALKAMIX™ , ALKAMIX, ALKAMIXMB6002, MB 6002, MB6002, Polyethylene, Linear Low Density, Polyethylene Linear Low Density, LLDPE, Polyethylene, PE, Qenos, PolyethyleneLinearLowDensity, 6002MB
Features
Features may also be described by the following terms: Antiblocking, Unspecified Antiblock, High Clarity.
Notes
1Typical properties: these are not to be construed as specifications.
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.