IDES Prospector Already have an account? Login Here

IDES

ALKAMIX™ MB6006

Linear Low Density Polyethylene

Supplied by Qenos Pty Ltd

The technical datasheet with complete property values for ALKAMIX™ MB6006 is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
Product Description
ALKAMIX MB6006 is a processing aid masterbatch based on a fluoropolymer compound at a concentration of 5 percent.

ALKAMIX MB6006 can be added to linear low density polyethylene (LLDPE) during extrusion to eliminate melt fracture (Sharkskin) type extrusion defects. The level required will vary according to extrusion equipment and type of LLDPE being used, however the recommended addition level is between 1 and 2 percent. ALKAMIX MB6006 is compatible with the process aid used in Alkatuff film polymers.

The maximum level of addition of MB6006 based on both good manufacturing practice and to ensure conformance to the requirements to the United States Food and Drug Administration Regulations CFR21 is 5 percent, when added to a polyethylene formulation free of any other additives.
General  
Material Status 
  • Commercial: Active
Availability 
  • Asia Pacific
Uses 
  • Blending
Forms 
  • Pellets
Physical
Nominal Value
Unit
Test Method
Density
g/cm³
 ASTM D1505
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: ALKAMIX™ MB6006, ALKAMIX MB6006, ALKAMIX™ , ALKAMIX, ALKAMIXMB6006, MB 6006, MB6006, Polyethylene, Linear Low Density, Polyethylene Linear Low Density, LLDPE, Polyethylene, PE, Qenos, PolyethyleneLinearLowDensity, 6006MB
Notes
1Typical properties: these are not to be construed as specifications.
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.