IDES Prospector Already have an account? Login Here

IDES

Alkatuff® 535

Linear Low Density Polyethylene

Supplied by Qenos Pty Ltd

The technical datasheet with complete property values for Alkatuff® 535 is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
Product Description
535 is a hexene copolymer linear low density polyethylene, designed for high quality cast film applications where higher stiffness is required. 535 is formulated with stabilisation additives, but contains no other additives.

535 is intended for cast film applications where high stiffness is required, such as overwrapping. 535 is not recommended for use in outdoor applications (especially applications where there may be prolonged exposure to sunlight, eg. agricultural films) without the addition of appropriate Hindered Amine based Light Stabilisers (HALS).

535 is suitable for food contact applications and conforms to the requirements of the United States Food and Drug Administration CFR 21 177.1520, paragraph (c), item 3.1.
General  
Material Status 
  • Commercial: Active
Availability 
  • Asia Pacific
Features 
  • Copolymer
  • Food Contact Acceptable
  • High Stiffness
Uses 
  • Cast Film
  • Film
 
Agency Ratings 
Forms 
  • Pellets
Processing Method 
  • Cast Film
  • Film Extrusion
 
Physical
Nominal Value
Unit
Test Method
Density
g/cm³
ASTM D1505
Melt Mass-Flow Rate (MFR) (190°C/2.16 kg)
g/10 min
ASTM D1238
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: Alkatuff® 535, Alkatuff 535, Alkatuff® , Alkatuff, Alkatuff535, 535, Polyethylene, Linear Low Density, Polyethylene Linear Low Density, LLDPE, Polyethylene, PE, Qenos, PolyethyleneLinearLowDensity
Features
Features may also be described by the following terms: High Stiffness.
Uses
Uses may also be described by the following terms: Cast Film.
Agency Ratings
This plastic material has 1 certifications from the following agencies (the number in parentheses shows the number of certifications for that agency): FDA (1).
Notes
1Typical properties: these are not to be construed as specifications.
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.