Already have an account? Login Here

IDES

Laminac 4123

Thermoset Polyester

Styrene, 30%

Supplied by Ashland Specialty Chemical

The technical datasheet with complete property values for Laminac 4123 is available to members of the Prospector Plastics Database.
Register to view full datasheet.

General

Material Status

Commercial: Active

Availability

North America

Filler / Reinforcement

Styrene, 30% Filler by Weight

Uses

Furniture

Agency Ratings

Appearance

Clear/Transparent

Straw

Forms

Pellets

Processing Method

Compression Molding

Physical	Nominal Value	Unit	Test Method
Apparent Density		g/cm³	ASTM D1895
Water Absorption (24 hr)		%	ASTM D570
Mechanical	Nominal Value	Unit	Test Method
Tensile Strength (Yield)		psi	ASTM D638
Tensile Elongation (Yield)		%	ASTM D638
Flexural Modulus		psi	ASTM D790
Flexural Strength (Yield)		psi	ASTM D790
Hardness	Nominal Value	Unit	Test Method
Durometer Hardness (Shore D, 0.125 in)			ASTM D2240
Thermoset	Nominal Value	Unit	Test Method
Pot Life		min
Thermoset Mix Viscosity (77°F)		cP	ASTM D2393
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: Laminac 4123, Laminac , Laminac4123, 4123, Polyester, Thermoset, Polyester Thermoset, Polyester, TS, Polyester TS, Thermoset, TS, Ashland Sp Chem, PolyesterThermoset, PolyesterTS
Agency Ratings
This plastic material has 1 certifications from the following agencies (the number in parentheses shows the number of certifications for that agency): MIL (1).

Notes

¹Typical properties: these are not to be construed as specifications.

Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.