IDES Prospector Already have an account? Login Here

IDES

Arnite® T08 200 (extrusion)

Polybutylene Terephthalate

Supplied by DSM Engineering Plastics

The technical datasheet with complete property values for Arnite® T08 200 (extrusion) is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
General  
Material Status 
  • Commercial: Active
Availability 
  • Asia Pacific
  • Europe
  
Features 
  • High Viscosity
RoHS Compliance 
Forms 
  • Pellets
Processing Method 
  • Extrusion
  • Injection Molding
  
Physical
Nominal Value
Unit
Test Method
Density
g/cm³
 ISO 1183
Melt Volume-Flow Rate (MVR) (250°C/2.16 kg)
in³/10min
 ISO 1133
Water Absorption
     ISO 62
Saturation, 73°F
%
  
Equilibrium, 73°F, 50% RH
%
  
Thermal
Nominal Value
Unit
Test Method
Melting Temperature 2
°F
 ISO 11357-3
Fill Analysis
Nominal Value
Unit
Test Method
Specific Heat Capacity of Melt
Btu/lb/°F
  
Thermal Conductivity of Melt
Btu·in/hr/ft²/°F
  
Additional Information
Nominal Value
Unit
Test Method
RSV 3
 
 Internal Method
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: Arnite® T08 200, Arnite T08 200, Arnite® T08 200 (extrusion), Arnite T08 200 extrusion, Arnite® , Arnite, ArniteT08200extrusion, T 08 200, T08 200, T 08 200 extrusion, T08200, T08 200 (extrusion), T08 200 extrusion, T08, 08200, 200extrusion, T08200extrusion, Polybutylene Terephthalate, PBT, Polyester, DSM EP, PolybutyleneTerephthalate, 08T
Features
Features may also be described by the following terms: High Viscosity.
Notes
1Typical properties: these are not to be construed as specifications.
210°C/min
3m-cresol, 1g/100ml
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.