Already have an account?
Login Here
IDES
AT 192
Low Density Polyethylene
Supplied by Celanese EVA Performance Polymers
The technical datasheet with complete property values for AT 192 is available to members of the
Prospector Plastics Database
.
Register to view full datasheet
.
Register to View Full Datasheet
Product Description
This homopolymer is suitable for use in carpet extrusion coating applications.
General
Material Status
Commercial: Active
Availability
North America
Features
High Flow
Homopolymer
Uses
Automotive Applications
Coating Applications
Fibers
Forms
Pellets
Processing Method
Extrusion Coating
Physical
Nominal Value
Unit
Test Method
Density
g/cm³
ASTM D1505
Melt Mass-Flow Rate (MFR)
(190°C/2.16 kg)
g/10 min
ASTM D1238
Mechanical
Nominal Value
Unit
Test Method
Tensile Strength
2
(Break)
psi
ASTM D638
Tensile Elongation
2
(Break)
%
ASTM D638
Flexural Modulus - 1% Secant
psi
ASTM D790
Hardness
Nominal Value
Unit
Test Method
Durometer Hardness
ASTM D2240
Shore A
Shore D
Thermal
Nominal Value
Unit
Test Method
Brittleness Temperature
°F
ASTM D746
Vicat Softening Temperature
°F
ASTM D1525
Melting Temperature
°F
DSC
Additional Information
The value listed as Density-Specific Gravity, ASTM D1505, was also tested in accordance with ASTM D1928 ProcC Mod.
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: AT 192, AT , AT192, 192, Polyethylene, Low Density, Polyethylene Low Density, LDPE, Polyethylene, PE, Celanese EVA, PolyethyleneLowDensity
Features
Features may also be described by the following terms: High Flow, High Melt, High MFI.
Uses
Uses may also be described by the following terms: Automotive Applications, Automotive Sector.
Notes
1
Typical properties: these are not to be construed as specifications.
2
Type IV, 2.0 in/min
Copyright © 2012
IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.