IDES Prospector Already have an account? Login Here

IDES

Ateva® 2861A

Ethylene Vinyl Acetate Copolymer

Supplied by Celanese EVA Performance Polymers

The technical datasheet with complete property values for Ateva® 2861A is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
Product Description
This resin is suitable for extrusion coating and coextrusion applications where low temperature sealing, superior heat seal bonding and hot tack characteristics are required.
General  
Material Status 
  • Commercial: Active
Availability 
  • North America
Additive 
  • Antioxidant
Features 
  • Antioxidant
  • Copolymer
  • Good Heat Seal
  • High Flow
  • Low Temperature Heat Sealability
Uses 
  • Coating Applications
  • Laminates
  
Agency Ratings 
Forms 
  • Pellets
Processing Method 
  • Coextrusion
  • Extrusion Coating
  • Laminating
Physical
Nominal Value
Unit
Test Method
Density
g/cm³
 ASTM D1505
Melt Mass-Flow Rate (MFR) (190°C/2.16 kg)
g/10 min
 ASTM D1238
Vinyl Acetate Content
wt%
  
Mechanical
Nominal Value
Unit
Test Method
Tensile Strength 2 (Break)
psi
 ASTM D638
Tensile Elongation 2 (Break)
%
 ASTM D638
Hardness
Nominal Value
Unit
Test Method
Durometer Hardness (Shore D)
 
 ASTM D2240
Thermal
Nominal Value
Unit
Test Method
Vicat Softening Temperature
°F
 ASTM D1525
Melting Temperature
°F
 DSC
Additional Information
The value listed as Density ASTM D1505, was also tested in accordance with ASTM D1928 Proc A.
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: Ateva® 2861A, Ateva 2861A, Ateva® , Ateva, Ateva2861A, 2861 A, 2861A, Ethylene Vinyl Acetate Copolymer, EVA, Polyethylene, PE, Celanese EVA, EthyleneVinylAcetateCopolymer, A2861
Features
Features may also be described by the following terms: High Flow, High Melt, High MFI, Low Temperature Heat Sealability, Low Temperature Heat Seal, Good Heat Seal.
Agency Ratings
This plastic material has 1 certifications from the following agencies (the number in parentheses shows the number of certifications for that agency): FDA (1).
Extrusion
Nominal Value
Unit
 
Melt Temperature
°F
  
Notes
1Typical properties: these are not to be construed as specifications.
2Type IV, 2.0 in/min
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.