Durolon G2510 PR001 Unigel Polycarbonate (Glass Fiber Reinforcement, 10%)

General

Material Status

Availability

Filler / Reinforcement

Features

Appearance

Forms

Processing Method

Physical	Nominal Value	Unit	Test Method
Specific Gravity
--			ASTM D792
--		g/cm³	ISO 1183
Molding Shrinkage - Flow		in/in	ASTM D955
Water Absorption (73°F, 24 hr)		%	ASTM D570
Mechanical	Nominal Value	Unit	Test Method
Tensile Modulus		psi	ASTM D638, ISO 527-2
Tensile Strength			ASTM D638, ISO 527-2
Yield		psi
Break		psi
Tensile Elongation (Break)		%	ASTM D638, ISO 527-2
Flexural Modulus		psi	ASTM D790, ISO 178
Flexural Strength		psi	ASTM D790, ISO 178
Impact	Nominal Value	Unit	Test Method
Notched Izod Impact (0.126 in)		ft·lb/in	ASTM D256
Hardness	Nominal Value	Unit	Test Method
Rockwell Hardness (M-Scale)			ASTM D785
Thermal	Nominal Value	Unit	Test Method
Deflection Temperature Under Load (264 psi, Unannealed)		°F	ASTM D648, ISO 75-2/A
CLTE - Flow		in/in/°F	ASTM D696
Electrical	Nominal Value	Unit	Test Method
Volume Resistivity		ohm·cm	ASTM D257
Dielectric Strength (0.0630 in)		V/mil	ASTM D149
Dielectric Constant			ASTM D150
60 Hz
1 MHz
Dissipation Factor			ASTM D150
60 Hz
1 MHz
Arc Resistance		sec	ASTM D495
Flammability	Nominal Value	Unit	Test Method
Glow Wire Ignition Temperature (0.126 in)		°F	IEC 60695-2-13
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: Durolon® G2510 PR001, Durolon G2510 PR001, Durolon® , Durolon, DurolonG2510PR001, G 2510 PR 001, G2510 PR001, G2510, 2510PR, PR001, G2510PR001, Polycarbonate, PC, Unigel, 2510G
Features
Features may also be described by the following terms: Good Dimensional Stability, Dimensionally Stable, High Hardness, Hard, High Heat Resistance, Good Strength.

Notes

¹Typical properties: these are not to be construed as specifications.

Durolon® G2510 PR001