IDES Prospector Already have an account? Login Here

IDES

SCLAIR® IG762-A

High Density Polyethylene

Supplied by NOVA Chemicals

The technical datasheet with complete property values for SCLAIR® IG762-A is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
General  
Material Status 
  • Commercial: Discontinued
Availability 
  • North America
Additive 
  • Antioxidant
Features 
  • Antioxidant
  • Fast Molding Cycle
  • Food Contact Acceptable
  • Good Impact Resistance
  • Good Processability
  • High Density
  • Low Viscosity
  • Low Warpage
Uses 
  • Crates
  • Pails
  
Agency Ratings 
Forms 
  • Pellets
Processing Method 
  • Compression Molding
  • Injection Molding
  
Physical
Nominal Value
Unit
Test Method
Specific Gravity
 
 ASTM D792
Melt Mass-Flow Rate (MFR) (190°C/2.16 kg)
g/10 min
 ASTM D1238
Mechanical
Nominal Value
Unit
Test Method
Tensile Strength 2
     ASTM D638
Yield, Compression Molded
psi
  
Yield, Injection Molded
psi
  
Break, Compression Molded
psi
  
Break, Injection Molded
psi
  
Tensile Elongation 2
     ASTM D638
Yield, Compression Molded
%
  
Yield, Injection Molded
%
  
Break, Compression Molded
%
  
Break, Injection Molded
%
  
Flexural Modulus - 1% Secant
     ASTM D790
Compression Molded
psi
  
Injection Molded
psi
  
Hardness
Nominal Value
Unit
Test Method
Durometer Hardness (Shore D)
 
 ASTM D2240
Thermal
Nominal Value
Unit
Test Method
Vicat Softening Temperature
°F
 ASTM D1525
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: SCLAIR® IG762-A, SCLAIR IG762A, SCLAIR® , SCLAIR, SCLAIRIG762A, IG 762, IG 762 A, IG762-A, IG762A, IG762:A, IG762/A, IG762+A, IG762_A, IG762 A, IG762, 762A, Polyethylene, High Density, Polyethylene High Density, HDPE, Polyethylene, PE, Nova Chemicals, PolyethyleneHighDensity, 762IG
Features
Features may also be described by the following terms: Low Warpage, Low Warp, Low Viscosity, High Density, High Specific Gravity, Good Processability, Easy Processing, Good Impact Resistance, Fast Cycle, Rapid Cycle, Productivity, Fast Molding Cycle.
Agency Ratings
This plastic material has 8 certifications from the following agencies (the number in parentheses shows the number of certifications for that agency): FDA (8).
Notes
1Typical properties: these are not to be construed as specifications.
22.0 in/min
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.