IDES Prospector Already have an account? Login Here

IDES

DOKI® PS 485

High Impact Polystyrene

Supplied by DIOKI d.d.

The technical datasheet with complete property values for DOKI® PS 485 is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
Product Description
DOKI® POLISTIREN 485 is elastomer modified, high impact polystyrene, especially developed for injection moulding.

DOKI® POLISTIREN 485 exhibits high melt flow properties - mould cavities fully filled up.
General  
Material Status 
  • Commercial: Active
Availability 
  • Europe
Features 
  • Food Contact Acceptable
  • Good Processability
  • High Flow
  • High Impact Resistance
  
Uses 
  • Engineering Parts
  • Thin-walled Parts
  
Agency Ratings 
 
Forms 
  • Pellets
Processing Method 
  • Injection Molding
Physical
Nominal Value
Unit
Test Method
Density
g/cm³
 ISO 1183
Apparent Density
g/cm³
 ISO 60
Melt Mass-Flow Rate (MFR) (230°C/1.2 kg)
g/10 min
 ISO 1133
Molding Shrinkage
%
  
Mechanical
Nominal Value
Unit
Test Method
Tensile Modulus
psi
 ISO 527-2
Tensile Stress
     ISO 527-2
Yield
psi
  
Break
psi
  
Tensile Strain (Break)
%
 ISO 527-2
Impact
Nominal Value
Unit
Test Method
Notched Izod Impact Strength
ft·lb/in²
 ISO 180/4A
Hardness
Nominal Value
Unit
Test Method
Rockwell Hardness (R-Scale)
 
 ISO 2039-2
Thermal
Nominal Value
Unit
Test Method
Vicat Softening Temperature
°F
 ISO 306/B50
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: DOKI® PS 485, DOKI PS 485, DOKI® , DOKI, DOKIPS485, PS 485, PS485, PS, Polystyrene, High Impact, Polystyrene High Impact, PS (HIPS), PS HIPS, Polystyrene, Dioki, PolystyreneHighImpact, PSHIPS, 485PS
Features
Features may also be described by the following terms: High Impact Resistance, Good Processability, Easy Processing, High Flow, High Melt, High MFI.
Uses
Uses may also be described by the following terms: Thin-walled Parts, Thin Walled Parts, Thin-wall Parts, Thin wall Parts, Thinwall Parts, Engineering Parts.
Agency Ratings
This plastic material has 4 certifications from the following agencies (the number in parentheses shows the number of certifications for that agency): EU (3), EC (1).
Injection
Nominal Value
Unit
 
Processing (Melt) Temp
°F
  
Mold Temperature
°F
  
Notes
1Typical properties: these are not to be construed as specifications.
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.