IDES Prospector Already have an account? Login Here

IDES

NORYL* EN95 Resin

Polyphenylene Ether + PS

Supplied by SABIC Innovative Plastics Asia Pacific

The technical datasheet with complete property values for NORYL* EN95 Resin is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
Product Description
Low heat, extrusion grade PPO/HIPS alloy.
General  
Material Status 
  • Commercial: Active
Availability 
  • Asia Pacific
Processing Method 
  • Injection Molding
Physical
Nominal Value
Unit
Test Method
Specific Gravity
 
 ASTM D792
Molding Shrinkage - Flow (0.126 in)
in/in
 Internal Method
Mechanical
Nominal Value
Unit
Test Method
Tensile Strength 2 (Yield)
psi
 ASTM D638
Tensile Elongation 2 (Break)
%
 ASTM D638
Flexural Modulus 3 (1.97 in Span)
psi
 ASTM D790
Flexural Strength 3 (Yield, 1.97 in Span)
psi
 ASTM D790
Impact
Nominal Value
Unit
Test Method
Notched Izod Impact (73°F)
ft·lb/in
 ASTM D256
Thermal
Nominal Value
Unit
Test Method
Deflection Temperature Under Load     ASTM D648
264 psi, Unannealed, 0.126 in
°F
  
264 psi, Unannealed, 0.252 in
°F
  
Related Terminology
This supplier and product may also be known by these terms: GE Plastics, LNP Engineering Plastics

Product names can be difficult to match. You may have searched any one of these terms to find this product: NORYL* EN95 Resin, NORYL EN95 Resin, NORYL* , NORYL, NORYLEN95Resin, EN 95 Resin, EN95 Resin, EN95, 95Resin, EN95Resin, Polyphenylene Ether + PS, Polyphenylene Ether PS, Polyphenylene Ether : PS, Polyphenylene Ether / PS, Polyphenylene Ether - PS, Polyphenylene Ether _ PS, Polyphenylene Ether PS, PPE+PS, PPEPS, PPE:PS, PPE/PS, PPE-PS, PPE_PS, PPE PS, Polyphenylene Ether, PPE, SABIC IP Asia, PolyphenyleneEtherPS, PolyphenyleneEther, PolyphenyleneEther_PS, 95EN
Generic Name
Generic Name may also be described by the following terms: PPO.
Injection
Nominal Value
Unit
 
Drying Temperature
°F
  
Drying Time
hr
  
Drying Time, Maximum
hr
  
Processing (Melt) Temp
°F
  
Notes
1Typical properties: these are not to be construed as specifications.
2Type I, 2.0 in/min
30.051 in/min
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.