IDES Prospector Already have an account? Login Here

IDES

Xyron™ AT600

Polyamide + PPE

Supplied by Asahi Kasei Chemicals Corporation

The technical datasheet with complete property values for Xyron™ AT600 is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
General  
Material Status 
  • Commercial: Active
Availability 
  • Africa & Middle East
  • Asia Pacific
  • Europe
  • North America
  
Automotive Specifications 
Processing Method 
  • Injection Molding
Physical
Nominal Value
Unit
Test Method
Density
g/cm³
 ISO 1183
Molding Shrinkage 2 (0.118 in)
%
 Internal Method
Mechanical
Nominal Value
Unit
Test Method
Tensile Stress (Yield, 73°F)
psi
 ISO 527-2
Tensile Strain (Break, 73°F)
%
 ISO 527-2
Flexural Modulus (73°F)
psi
 ISO 178
Flexural Strength (73°F)
psi
 ISO 178
Impact
Nominal Value
Unit
Test Method
Charpy Notched Impact Strength 3 (73°F)
ft·lb/in²
 ISO 179
Thermal
Nominal Value
Unit
Test Method
Deflection Temperature Under Load (264 psi, Unannealed)
°F
 ASTM D648
CLTE - Flow (-22 to 149°F)
in/in/°F
 ISO 11359-2
Electrical
Nominal Value
Unit
Test Method
Volume Resistivity (73°F)
ohm·cm
 IEC 60093
Dielectric Constant
     IEC 60250
100 Hz
 
  
1 MHz
 
  
Dissipation Factor
     IEC 60250
100 Hz
 
  
1 MHz
 
  
Electric Strength 4 (0.0787 in)
V/mil
 IEC 60243-1
Related Terminology
This supplier and product may also be known by these terms: Thermofil, Asahi Thermofil

Product names can be difficult to match. You may have searched any one of these terms to find this product: Xyron™ AT600, Xyron AT600, Xyron™ , Xyron, XyronAT600, AT 600, AT600, Polyamide + PPE, Polyamide PPE, Polyamide : PPE, Polyamide / PPE, Polyamide - PPE, Polyamide _ PPE, Polyamide PPE, Nylon+PPE, NylonPPE, Nylon:PPE, Nylon/PPE, Nylon-PPE, Nylon_PPE, Nylon PPE, Polyamide, Nylon, Asahi Kasei, PolyamidePPE, Polyamide_PPE, 600AT
Automotive Specifications
This plastic material has approval for 1 automotive specifications from the following agencies (the number in parentheses shows the number of specifications for that agency): GM (1).
Injection
Nominal Value
Unit
 
Drying Temperature
°F
  
Drying Time
hr
  
Processing (Melt) Temp
°F
  
Mold Temperature
°F
  
Notes
1Typical properties: these are not to be construed as specifications.
2120x80x3 mm
34 mm
4Short Time
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.