IDES Prospector Already have an account? Login Here

IDES

Diaterm® A27 GF30V0

Polyamide 6

Glass Fiber Reinforcement, 30%

Supplied by DTR S.r.l. (Develop Thermoplastic Resins)

The technical datasheet with complete property values for Diaterm® A27 GF30V0 is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
General  
Material Status 
  • Commercial: Active
Availability 
  • Europe
Filler / Reinforcement 
  • Glass Fiber Reinforcement, 30% Filler by Weight
Features 
  • Flame Retardant
Forms 
  • Pellets
Physical
Nominal Value
Unit
Test Method
Specific Gravity
 
 ASTM D792
Mechanical
Nominal Value
Unit
Test Method
Tensile Strength
psi
 ASTM D638
Impact
Nominal Value
Unit
Test Method
Notched Izod Impact (73°F)
ft·lb/in
 ASTM D256
Thermal
Nominal Value
Unit
Test Method
Deflection Temperature Under Load
     ASTM D648
66 psi, Unannealed
°F
  
264 psi, Unannealed
°F
  
Vicat Softening Temperature
°F
 ASTM D1525 2
Flammability
Nominal Value
Unit
Test Method
Flame Rating - UL
 
 UL 94
Glow Wire Ignition Temperature
°F
 IEC 60695-2-13
Additional Information
Water Absorption, DIN 53714, 23°C, 50% RH: 2.1%
Burning Rate, DIN 75200: <100mm/min
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: Diaterm® A27 GF30V0, Diaterm A27 GF30V0, Diaterm® , Diaterm, DiatermA27GF30V0, A 27 GF 30 V 0, A27 GF30V0, A27, 27GF, GF30, 30V, V0, A27GF30V0, Polyamide 6, Nylon 6, Polyamide, Nylon, pa6, DTR, Polyamide6, Nylon6, 27A
Generic Name
Generic Name may also be described by the following terms: PA6.
Injection
Nominal Value
Unit
 
Drying Temperature
°F
  
Drying Time
hr
  
Notes
1Typical properties: these are not to be construed as specifications.
2Rate B (120°C/h), Loading 2 (50 N)
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.