Alastian PE LD08-1 Alastian Polyethylene, Low Density

General

Material Status

Availability

Features

Uses

Forms

Processing Method

Physical	Nominal Value	Unit	Test Method
Density		g/cm³	ISO 1183
Melt Mass-Flow Rate (MFR) (190°C/2.16 kg)		g/10 min	ISO 1133
Mechanical	Nominal Value	Unit	Test Method
Tensile Modulus		psi	ISO 527-2
Tensile Stress (Yield)		psi	ISO 527-2
Coefficient of Friction			ISO 8295
Films	Nominal Value	Unit	Test Method
Film Thickness - Tested		mil
Film Thickness - Recommended / Available
Tensile Strength			ISO 527-3
MD: 2.0 mil, Blown Film		psi
TD: 2.0 mil, Blown Film		psi
Tensile Elongation			ISO 527-3
MD: Break, 2.0 mil, Blown Film		%
TD: Break, 2.0 mil, Blown Film		%
Hardness	Nominal Value	Unit	Test Method
Shore Hardness (Shore D)			ISO 868
Ball Indentation Hardness (H 49/30)		psi	ISO 2039-1
Thermal	Nominal Value	Unit	Test Method
Vicat Softening Temperature		°F	ISO 306/A50
Melting Temperature
--²		°F
--		°F	ISO 3146
Additional Information	Nominal Value	Unit	Test Method
Failure Energy (2.0 mil)		ft·lb/in	DIN 53373
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: Alastian PE LD08-1, Alastian PE LD081, Alastian PE , AlastianPELD081, AlastianPE, LD 08, PELD 08 1, PELD 08, PELD08-1, PELD081, PELD08:1, PELD08/1, PELD08+1, PELD08_1, PELD08 1, PELD08, LD 08 1, LD08-1, LD081, LD08:1, LD08/1, LD08+1, LD08_1, LD08 1, LD08, 081, Polyethylene, Low Density, Polyethylene Low Density, LDPE, Polyethylene, PE, Alastian, PolyethyleneLowDensity, 08LD, 08PELD
Features
Features may also be described by the following terms: Good Processability, Easy Processing, Good Heat Seal, Shrinkable.

Notes

¹Typical properties: these are not to be construed as specifications.

²Film

Alastian PE LD08-1