IDES Prospector Already have an account? Login Here

IDES

Borealis LE0592M

Crosslinked Polyethylene

Supplied by Borealis AG

The technical datasheet with complete property values for Borealis LE0592M is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
Product Description
LE0592M is a crosslinkable black polyethylene compound, specially designed for bonded semiconductive screen applications.

LE0592M is intended for bonded semiconductive applications in XLPE low and medium voltage cables.

LE0592M meets the applicable requirements as below when processes using sound extrusion practice and testing procedure:
  • BS 6622
General  
Material Status 
  • Commercial: Active
Availability 
  • Africa & Middle East
  • Asia Pacific
  • Europe
  • South America
  
Features 
  • Crosslinkable
  • Semi Conductive
  
Uses 
  • Insulation
  • Wire Jacketing
  
Agency Ratings 
Forms 
  • Granules
Processing Method 
  • Extrusion
Physical
Nominal Value
Unit
Test Method
Density 2
g/cm³
 ISO 1183
Moisture Content 3
ppm
  
Mechanical
Nominal Value
Unit
Test Method
Tensile Stress (Yield)
psi
 ISO 527-2/25
Tensile Strain (Break)
%
 ISO 527-2/25
Thermal
Nominal Value
Unit
Test Method
Hot Set     IEC 60811-2-1
392°F 4
%
  
392°F 5
%
  
Aging
Nominal Value
Unit
Test Method
Retention of Tensile Properties - After Ageing 240 h (275°F)
%
 IEC 60811-1-2
Electrical
Nominal Value
Unit
Test Method
Volume Resistivity     ISO 3915
-- 6
ohm·cm
  
-- 7
ohm·cm
  
Additional Information
Nominal Value
Unit
Test Method
Gottfert Elastograph
in·lb
  
Monsanto ODR
ft·lb
  
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: Borealis LE0592M, Borealis , BorealisLE0592M, LE 0592 M, LE0592M, LE0592, 0592M, Polyethylene, Crosslinked, Polyethylene Crosslinked, XLPE, Polyethylene, PE, PolyethyleneCrosslinked, 0592LE
Features
Features may also be described by the following terms: Semi-Conductive, Semi Conductive.
Agency Ratings
This plastic material has 1 certifications from the following agencies (the number in parentheses shows the number of certifications for that agency): BS (1).
Extrusion
Nominal Value
Unit
 
Drying Temperature
°F
  
Drying Time
hr
  
Melt Temperature
°F
  
Notes
1Typical properties: these are not to be construed as specifications.
2ISO 1872-2
3Karl Fischer-titration, 1.000 ppm
4Permanent deformation, 0.20 MPa
5Elongation under load, 0.20 MPa
690°C
723°C
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.