IDES Prospector Already have an account? Login Here

IDES

Borealis LE4295

Polyethylene

Mineral Filler

Supplied by Borealis AG

The technical datasheet with complete property values for Borealis LE4295 is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
Product Description
LE4295 is a mineral filled crosslinkable polyethylene compound.
General  
Material Status 
  • Commercial: Active
Availability 
  • Africa & Middle East
  • Asia Pacific
  • Europe
Filler / Reinforcement 
  • Mineral Filler
Features 
  • Crosslinkable
Uses 
  • Cable Jacketing
  • Insulation
  
Agency Ratings 
Appearance 
  • Black
Forms 
  • Granules
Processing Method 
  • Extrusion
Physical
Nominal Value
Unit
Test Method
Density
g/cm³
 ISO 1183/D
Mechanical
Nominal Value
Unit
Test Method
Tensile Stress (Yield)
psi
 ISO 527-2/25
Tensile Strain (Break)
%
 ISO 527-2/25
Electrical
Nominal Value
Unit
Test Method
Volume Resistivity
ohm·cm
 IEC 60093
Dielectric Constant (50 Hz)
 
 IEC 60250
Dissipation Factor (50 Hz)
 
 IEC 60250
Electric Strength
V/mil
 IEC 60243-1
Additional Information
Moisture, Karl Fischer Titration, Max 600: 200 ppm
Change of Tensile Properties after ageing, IEC 60811-1-2, 135°C, 240h: <20 %
Hot Set Test, Elongation under Load, IEC 60811-2-1, 200°C, 0.20 MPa: 60 %
Hot Set Test, Permanent Deformation, IEC 60811-2-1, 200°C, 0.20 MPa: 5 %
Monsanto ODR, ASTM D2084: 60 dNm
Methanol Wash, BTM00118, Max 1500: 1000 ppm
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: Borealis LE4295, Borealis , BorealisLE4295, LE 4295, LE4295, Polyethylene, Unspecified, Polyethylene Unspecified, PE, Unspecified, PE Unspecified, Polyethylene, PE, PolyethyleneUnspecified, PEUnspecified, 4295LE
Agency Ratings
This plastic material has 5 certifications from the following agencies (the number in parentheses shows the number of certifications for that agency): NEMA (1), ICEA (1), DIN (1), NF (1), ISO (1).
Extrusion
Nominal Value
Unit
 
Cylinder Zone 1 Temp.
°F
  
Cylinder Zone 2 Temp.
°F
  
Cylinder Zone 3 Temp.
°F
  
Cylinder Zone 4 Temp.
°F
  
Melt Temperature
°F
  
Die Temperature
°F
  
Notes
1Typical properties: these are not to be construed as specifications.
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.