IDES Prospector Already have an account? Login Here

IDES

G-Lex F55HM0003

High Density (HMW) Polyethylene

Supplied by Gas Authority of India Limited

The technical datasheet with complete property values for G-Lex F55HM0003 is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
General  
Material Status 
  • Commercial: Active
Availability 
  • Asia Pacific
Features 
  • Good Processability
  • Good Weather Resistance
  • High ESCR (Stress Crack Resist.)
  • High Impact Resistance
  • High Molecular Weight
  • Low Temperature Impact Resistance
Uses 
  • Bags
  • Film
  • Liners
  • Packaging
  
Forms 
  • Pellets
Processing Method 
  • Film Extrusion
Physical
Nominal Value
Unit
Test Method
Density
g/cm³
 ASTM D1505
Melt Mass-Flow Rate (MFR)
     ASTM D1238
190°C/2.16 kg
g/10 min
  
190°C/21.6 kg
g/10 min
  
Mechanical
Nominal Value
Unit
Test Method
Coefficient of Friction
     ASTM D1894
vs. Itself - Dynamic, Blown Film
 
  
vs. Itself - Static, Blown Film
 
  
Films
Nominal Value
Unit
Test Method
Film Thickness - Tested
mil
  
Tensile Strength
     ASTM D882
MD: Break, 0.59 mil, Blown Film
psi
  
TD: Break, 0.59 mil, Blown Film
psi
  
Tensile Elongation
     ASTM D882
MD: Break, 0.59 mil, Blown Film
%
  
TD: Break, 0.59 mil, Blown Film
%
  
Dart Drop Impact (0.59 mil, Blown Film)
g
 ASTM D1709
Elmendorf Tear Strength
     ASTM D1922
MD: 0.59 mil, Blown Film
g
  
TD: 0.59 mil, Blown Film
g
  
Additional Information
Data gathered from 15 µ blown film with a BUR of 4:1.
Related Terminology
Product names can be difficult to match. You may have searched any one of these terms to find this product: G-Lex F55HM0003, GLex F55HM0003, G-Lex , GLex, G:Lex, G/Lex, G+Lex, G_Lex, G Lex, GLexF55HM0003, F 55 HM 0003, F55HM0003, F55, 55HM, HM0003, Polyethylene, High Density, Polyethylene High Density, Polyethylene, High Density (HMW), Polyethylene High Density HMW, HDPE, HMW, HDPE HMW, Polyethylene, PE, Gas Authority, PolyethyleneHighDensityHMW, HDPEHMW, 55F
Features
Features may also be described by the following terms: Good Weather Resistance, Weather Resistant, Good Processability, Easy Processing, Low Temperatuer Impact Resistance, Low Temp Impact Resistance, High Impact Resistance, High Environmental Stress Cracking Resistance, High ESCR, Stress Cracking Resistant, High Molecular Weight, High MW.
Notes
1Typical properties: these are not to be construed as specifications.
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.