IDES Prospector Already have an account? Login Here

IDES

Dryflex® 500040

Styrene Ethylene Butylene Styrene Block Copolymer

Supplied by ELASTO

The technical datasheet with complete property values for Dryflex® 500040 is available to members of the Prospector Plastics Database.
Register to view full datasheet.
Register to View Full Datasheet
General  
Material Status 
  • Commercial: Active
Availability 
  • Europe
Features 
  • Good Chemical Resistance
  • Good Colorability
  • Good UV Resistance
  • Good Weather Resistance
  • Ozone Resistant
  • Recyclable Material
Appearance 
  • Colors Available
  • Translucent
  
Forms 
  • Granules
Processing Method 
  • Extrusion
  • Injection Molding
  
Physical
Nominal Value
Unit
Test Method
Specific Gravity
 
 ASTM D792
Melt Mass-Flow Rate (MFR) (190°C/2.16 kg)
g/10 min
 ASTM D1238
Molding Shrinkage - Flow
in/in
  
Mechanical
Nominal Value
Unit
Test Method
Tensile Modulus
     ASTM D638
100% Secant
psi
  
300% Secant
psi
  
Tensile Strength
psi
 ASTM D638
Tensile Elongation (Break)
%
 ASTM D638
Elastomers
Nominal Value
Unit
Test Method
Tear Strength
lbf/in
 ASTM D624
Hardness
Nominal Value
Unit
Test Method
Durometer Hardness (Shore A, 0.157 in)
 
 ASTM D2240
Thermal
Nominal Value
Unit
Test Method
Service Temperature
°F
  
Related Terminology
This supplier and product may also be known by these terms: British Vita

Product names can be difficult to match. You may have searched any one of these terms to find this product: Dryflex® 500040, Dryflex 500040, Dryflex® , Dryflex, Dryflex500040, 500040, Styrene Ethylene Butylene Styrene Block Copolymer, SEBS, Thermoplastic Elastomer, TPE, Elasto, StyreneEthyleneButyleneStyreneBlockCopolymer, ThermoplasticElastomer
Features
Features may also be described by the following terms: Good Colorability, Good Weather Resistance, Weather Resistant, Good UV Resistance, UV Resistant, Ultraviolet Resistant, Ultraviolet Light Resistant, Good Chemical Resistance, Chemical Resistant.
Injection
Nominal Value
Unit
 
Rear Temperature
°F
  
Middle Temperature
°F
  
Front Temperature
°F
  
Mold Temperature
°F
  
Notes
1Typical properties: these are not to be construed as specifications.
 
IDES
Copyright © 2012 IDES
The information presented on this datasheet was acquired by IDES from the producer of the material. IDES makes substantial efforts to assure the accuracy of this data. However, IDES assumes no responsibility for the data values and strongly encourages that upon final material selection, data points are validated with the material supplier.